skew rolling

Calculation on Axial SiLding Field of Contact Area of Deformation in Skew Rolling

斜轧变形区接触面上轴向滑移场计算

互联网摘选

Cold Skew Rolling Test and Analysis of Steel Tube

钢管冷斜轧试验及结果分析

互联网摘选

Pass design for two-groove skew rolling aluminum ball

双头斜轧铝球的孔型设计

互联网摘选

The Method of Determining the First Contact Point and It's Characteristic Angle on Skew-rolling

确定斜轧中最先接触点及其特征角的方法

互联网摘选

This thesis studies the effect of wide& high ratio, bump ratio and reduction ratio on the skew ratio in plain roller rolling square bar through simulated hot rolling steel by steel roller rolling lead.

通过钢辊轧制铅件模拟热轧钢件，研究了平辊轧制矩形件过程，轧件的宽高比、鼓形比和压下率三个参数对脱方的影响。

互联网摘选

Rolling force is the important parameter for skew rolling process design of anchor rod.

轧制力是斜轧锚杆工艺设计的重要参数,轧制力的变化受到各工艺参数的影响.

互联网摘选

Calculation and Design for caster angle of Cardan Shaft in Skew Rolling Mill

斜轧机的万向联结轴倾角的计算与设计

互联网摘选

New method of groove designing for ball skew rolling

斜轧钢球孔型设计新方法

互联网摘选

In this paper, the principles which should be adhered to when designing skew rolling tool and the pass design for three-roller combining piercing and rolling are discussed.

本文论述了斜轧工具设计所应遵循的原则与三辊联合穿轧的孔型设计。

互联网摘选

The 3-dimension finite element models of tool and workpiece in the skew rolling process were built up with ANSYS/ LS-DYNA. Computer simulations on the ladder shaft in skew rolling under different parameters were conducted.

采用ANSYS/LS-DYNA软件，建立了斜轧零件基本变形过程的三维有限元分析模型，对不同工况下的斜轧过程进行了计算机数值模拟分析。

互联网摘选

Based on the fact that the skew roll groove width is same in rolling steel sashes of 3205 series, a metal transfer formula was deduced between leg and web during plastic deformation.

本文以轧制3205型窗框钢孔型设计中各斜轧孔型宽度相等为例，从金属不均匀变形出发，根据体积不变定律推导出计算变形过程中腰部与各腿部之间金属体积的转移公式。

互联网摘选

In order to prevent the slide block of cardan shaft from wearing seriously, the cardan shaft in the skew rolling mill must be rational designed.

为了避免由于万向联接轴的滑块严重磨损造成斜轧机传动系统的冲击和噪音等问题，必须合理地设计斜轧机的万向联接轴。

互联网摘选

NC Machining of Roller of Skew Rolling and Error Analysis

斜轧球类件轧辊的数控车削加工及误差分析

互联网摘选