scuffing

['skʌfɪŋ]
  • scuffing
  • n.

    刮[磨,擦,划]伤;

  • v.

    使磨损( scuff的现在分词 );拖着脚走;

纠错 数据更新时间:2026-04-18 13:26:05
1、

Excellent anti-scuffing property gives special protection where high speed, high pressure and temperature conditions are experienced.

极佳的抗磨损特性,令机件在高速, 高压和高温之下能有效地受到保护.

互联网摘选

2、

Elias toyed with his own gold goblet, scuffing it along the crescent-shaped scars in the oak.

Elias把玩着他自己的黄金的酒杯, 沿着橡木桌上的新月形的疤,磨着.

互联网摘选

3、

Influence of Lubrication Oil on the Scuffing Resistant of Sliding Friction Pairs

润滑油对滑动摩擦副咬死性能的影响

互联网摘选

4、

Effect of Lubricating Oil Temperature on Gear's Scuffing Resistance

润滑油温度对齿轮胶合承载能力的影响

互联网摘选

5、

Wade edged closer to him, scuffing one foot and looking unhappy.

韦德向他靠近些, 一只脚在地板上擦来擦去,显得很不高兴.

飘(部分)

6、

Improvement of Scuffing of Cylinder Bore for 490 High Speed Diesel Engine

490型高速柴油机拉缸的改进研究

互联网摘选

7、

A study of the cold scuffing of low speed and high load gears

低速重载齿轮冷胶合机理及试验研究

互联网摘选

8、

The maximum load on a bearing should always be smaller than the relief load scuffing.

轴承上的最大负荷应该总是小于其卸载负荷.

互联网摘选

9、

Study on the scuffing strength of micro-segment helical gear

斜齿微线段齿轮胶合承载能力的研究

互联网摘选

10、

Analysis and Calculation of Fuzzy Reliability on Scuffing Resistance of Gear Drive

齿轮传动抗胶合模糊可靠性分析与计算

互联网摘选

11、

The stretch-cleanseor, curing film hold synchronization expansion, film has excellent resistance to stretching and scuffing.

在拉伸或洗涤过程中,固化膜与底材同步伸缩, 固化膜具有极好的抗拉伸和耐摩擦性.

互联网摘选

12、

The scuffing-resistant capability of friction pairs is enhanced with reducing sliding velocity.

摩擦副的抗胶合能力都随相对滑动速度的提高而下降。

互联网摘选

13、

The development of scuffing-type damage is illustrated in Fig . 1.11.

胶合形式损坏的发展情况示于图1.11中.

词典精选例句

14、

Experimental Simulation and Theoretical Analysis on Scuffing Failure of Piston Ring Cylinder Liner

内燃机活塞环-缸套擦伤的理论分析与试验模拟

互联网摘选

15、

Hot load and mechanical load coupling make piston to produce crackle, piston-ring glued and scuffing of cylinder bore and so on.

热负荷和机械负荷耦合将导致活塞产生裂纹、活塞环胶结以及拉缸等。

互联网摘选

16、

Experimental Study on the Reliability of Extrapolation of Critical Temperature in Gear Scuffing

反推齿轮胶合临界温度可靠性的试验研究

互联网摘选

17、

Research on Cylinder Scuffing Simulation Experiment of Diesel Engine

柴油机拉缸故障模拟试验研究

互联网摘选

18、

The temperature effect of scuffing in sliding contact of steel is explored from the point of view of frictional temperature.

作者从摩擦温度的观点考察了钢在滑动接触中擦伤的温度效应。擦伤试验是在环-块试验机上进行的。

互联网摘选

19、

Study on calculating and test method for gear scuffing

齿轮胶合的计算和试验研究

互联网摘选

20、

Study of monitoring on line about the gear scuffing test

齿轮胶合试验在线监测方法研究

互联网摘选

21、

Mechanism analysis and betterment measure on scuffing of hydraulic pressure equipment

液压升降装置拉缸机理分析和改进措施

互联网摘选

22、

Therefore, use a per-printing technology must be in the scuffing better ink and light oil.

因此, 使用预印技术必须采用耐摩擦性较好的油墨和光油.

互联网摘选

23、

Reliability Analysis and Calculation of Scuffing Load Capacity for Gear Transmission by Flash Temperature Method

基于闪温法的传动齿轮抗胶合可靠度分析与计算

互联网摘选

24、

The Experimental Research on the Scuffing Load Capacity of Worm Gear Oil

蜗轮蜗杆油胶合承载能力试验研究

互联网摘选

25、

The anti scuffing, friction reducing and wear resistant properties were investigated systematically on a pin on disc tester under engine oil lubrication condition.

用销盘试验机在机械油润滑条件下对渗硫表面的抗擦伤性能,减摩及耐磨性能进行了系统研究。

互联网摘选

26、

Smaller particle of the talc leads to higher smoothness, gloss, air permeability, ink set-off and scuffing properties, but reduces surface strength and printing contrast.

粒度较小的滑石粉导致更佳的平滑度、光泽度、透气度、油墨干燥性以及耐摩擦性,但也导致更低的表面强度和印刷对比度。

互联网摘选

27、

New Variation of Critical Temperature in Gear Scuffing

齿轮胶合临界温度的变化新规律

互联网摘选

28、

Standard test method for scuffing load capacity of gears

GB/T13672-1992齿轮胶合承载能力试验方法

互联网摘选

29、

Research of Test on Gear Scuffing and Monitoring Technique

齿轮胶合的试验研究及其监测技术

互联网摘选

30、

The rest of us started giggling, scuffing our feet on the floor.

全班的同学都在笑, 把地板擦得很响.

汉英文学 - 中国现代小说

  • 相关词组
  • 今日热词
  • 热门搜索

英语网英语词典(dict.25820.com)为您提供在线翻译英语词典单词大全英译汉汉译英等英语服务!可按单词字数词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈