truss element的例句大全

When the finite element method is used to analyze the suspension bridge, the truss element or cable element can be used to simulate the main cable and the hanger.

应用有限元方法对悬索桥进行受力分析时，可采用轴向拉力对刚度贡献的桁架单元或索单元来模拟主缆和吊杆。

互联网摘选

According to the slab-girder element above, the space nonlinear finite element method to through steel truss composite bridge is put forward. Its box figure is given and its program is made.

基于本文提出的板梁单元，给出了下承式钢桁结合梁桥的空间非线性有限元分析方法，绘出了程序的框图，编制了相应的计算程序。

互联网摘选

Finite Element Analysis and Optimum Design for Thrust Truss Structure of Spacecraft

航天器发动机推力支架桁架结构的有限元分析与优化设计

互联网摘选

Finite-Element Model for the Thermal Analysis of Large Main Truss of Space Station'Solar-Array

大型空间桁架结构热分析的有限元方法

互联网摘选

Using the Thermal-Structure integrative analysis method, it can figure out thermal loads of equivalent node resulted from the temperature of truss pole element which is the primary structure of the deployable antenna, and it also construct the relevant finite element equation of thermal elasticity.

采用热结构一体化的分析方法，计算出组成可展开天线主要结构桁架杆单元由于温度引起的等效结点热载荷，并建立了相应的热弹性有限元方程。

互联网摘选

Plate-beam element in calculating plate-truss composite structure

板桁组合结构分析中的板梁单元

互联网摘选

Non-linear Finite Element Analysis of Fire Resistance for Steel Truss Dome

钢网壳抗火非线性有限元分析

互联网摘选

Finite element model of truss in ANSYS is built, quadruplet bars are selected, in every group one bar is designated randomly and early damage is simulated through receding its elasticity;

利用ANSYS进行桁架结构有限元模型的建立，选定四组杆件，在每一组中随机指定一根，通过降低其弹性模量来模拟早期损伤；

互联网摘选

Based on a shaking table experiment of steel reinforced concrete frame-shearwall structure model with steel truss transfer stories and finite element analysis, its seismic performance is studies deeply.

本文通过整体模型振动台试验研究和有限元理论计算分析，对带高位大跨度钢桁架转换层型钢混凝土框架&剪力墙结构的抗震性能问题进行了深入研究。

互联网摘选

The Web steel truss beam is simulated with three-dimensional beam element, and the equivalent bending rigidity of the beam could be obtained by bending test.

模型中，桁架柱采用三维梁单元模拟，其等效弯曲刚度利用弯曲试验直接获得。

互联网摘选

Finite element model of a cubic space truss is set up and modality analysis are done as an example.

并以一立方体桁架式伸展机构为例，详细探讨了它的有限元建模方法和计算分析过程。

互联网摘选

Based on the steel truss bridge mode of 1 ∶ 10 scale, the identification methods of bridge structure damage detection was discussed. By finite element method and hammer pound method with Varied-Time-Base ( VTB) technology, the modal test analysis of bridge modal was done.

本文以1∶10钢桁架桥梁模型为研究对象，用有限元模型及实验模型进行局部损伤的识别，实验采用锤击法及变时基（VTB）技术对桥梁模型进行了模态分析。

互联网摘选

A series of testing research and finite element analysis were done in Wuhan University of Technology for the Web steel truss beam, truss column, wall and joint.

武汉理工大学针对无比轻钢龙骨体系的桁架梁、桁架柱、墙体及节点等做了一系列的试验研究和有限元分析。

互联网摘选

The paper mainly does work as follows: Though simulating the shape forming process of post-tensioned and shaped dome by nonlinear finite element analysis, the post-tensioning method and joint connections in the new single-chorded plane space truss as well as the forming shape of dome are studied.

通过非线性有限元模拟成形分析，对新型单弦杆平板网架中的后张拉方法、节点连接形式以及穹顶成形形状进行了研究，为试验模型的建立奠定了理论基础。

互联网摘选

Finite element analysis on compressive bearing capacity of welded hollow spherical joints of space truss

网架焊接空心球节点受压承载力的有限元分析

互联网摘选

Finite element analysis of reticulated shell steel truss-film structure for the dome of Nanning Exhibition Center under wind load

南宁国际会展中心穹顶网壳钢-索膜结构风载作用分析

互联网摘选

finite element analysis of static work behavior of shs truss with gapped k-joints

K型间隙方钢管桁架静力工作性能的有限元分析

互联网摘选

three nodal section truss segment finite element method of spatial calculation for truss girder structure

桁梁结构空间计算的三节点截面桁段有限元法

互联网摘选

considering secondary bend force of structure, 3-d fem can use 3-d elastic beam element to simulate truss members, which can accomplish actually mechanic behaviors simulation of existing continuous steel truss bridges.

空间计算模型采用空间梁单元模拟桁架桥杆件，可以考虑弯曲次内力和结构空间受力行为，能够比较真实地实现连续桥梁的工作状态模拟。

互联网摘选

for solving the problem of the secondary stress of square steel tube trapezoid roof truss when compiling national standards drawings, the finite element analysis program ansys is used to calculate and analyze.

运用有限元软件ANSYS，对在编制《方钢管屋架国家标准图集》过程中遇到的次应力问题进行分析。

互联网摘选