shear force的例句大全

The new rotor used in mixer has strong shear force. The waste rubber with the untying cross-linking reagent in the mixing process could achieve regeneration of waste rubber under relatively low temperature.

该新型八棱转子具有强剪切力，能使废橡胶在混炼过程中，在解联剂的作用下，实现再生。

互联网摘选

in order to solve the problem that the vertical force is larger than the admissible anti-shear force in the slice division plane, use the transmit coefficient method to make corrections.

滑坡推力计算中，为解决分界面上垂直分力大于容许抗剪力的矛盾，提出了采用传递系数法进行修正的方法。

互联网摘选

Owing to the swelling of fingernail matrix and recovery of fibers, the indents and scratches on the fingernail samples could be recovered by dipped in water within 10 min. Compared to normal force, the fingernail is more easily damaged by shear force.

由于指甲的基质溶胀和纤维回弹，浸泡在水中10min以内，指甲的压痕和划痕变形均可恢复。相对于法向力，切向力更容易使指甲发生破坏。

互联网摘选

Research on the textural changes of Rongchang suckling pig in the process. ( 1) Adding the nitrite pickled, the hardness and shear force of the pig are reduced.

荣昌乳猪加工过程中的质构变化研究。（1）随着亚硝酸盐添加量的增加，荣昌乳猪腌制后的硬度和剪切力逐渐降低、残留量增加。

互联网摘选

A differential operator arisen from an Euler-Bernoulli beam equation under boundary shear force feedback control is studied. It is shown that the root subspace of the system operator is complete in the energy Hilbert space.

讨论了一个在边界上有剪力反馈控制的Euler-Bernoulli梁方程，证明了其广义本征函数生成的根子空间在能量Hilbert空间中是完备的。

互联网摘选

Considering the change of the load transverse distribution coefficient along the bridge span, the maximum value of shear force at supporting point caused by uniformly distributed lane load is calculated by integral method.

考虑荷载横向分布系数m沿桥跨方向的变化，采用积分法对车道均布荷载引起的支点最大剪力进行了计算。

互联网摘选

The result shows that the WTZN clay-free drilling fluid viscosifier is quite effective and improves dynamic shear force and cutting carrying ability.

结果表明：WTZN无固相钻井液增粘剂增粘、提高动切力效果好，有利于提高钻井液携带岩屑能力；

互联网摘选

The assembly of tuning fork and optical fiber probe is used to perform the shear force distance control.

粘接音叉和光纤探针的胶粘剂对由石英音叉和光纤探针构成剪切力控距体系的品质因数有明显的影响。

互联网摘选

Non optical methods of sample tip distance regulation based on shear force in SNOM

近场光学显微镜中利用剪切力原理进行样品/探针间距测控的非光学方法

互联网摘选

Non optical methods of sample tip distance regulation based on shear force which include emission detection with PMT, quartz tuning fork, capacitance, piezoeffect, impedance are reviewed in this paper.

本文综述了扫描近场光学显微镜发展以来所出现的基于剪切力原理进行样品／探针间距的探测的一些主要的非光学方法。

互联网摘选

A nonoptical shear force method for tip sample distance regulation

一种探针-样品距离的切变力控制新方法

互联网摘选

The high tensile stress parallel to the interface exists at the whisker/ reaction layer interface and in TiC near the interface, at which failure occurs easily when shear force is applied.

SiC晶须/反应层界面及其附近的反应产物TiC内具有较高的平行于界面的拉应力，当连接界面承受剪力作用时，SiC晶须/反应层界面和TiC处极易破坏。

互联网摘选

The effect of Na~+, F~-and shear force etc.

研究了Na~+、F~-、剪切力以及接种量等对用于生物冶金的一株中度嗜热嗜酸菌生长的影响。

互联网摘选

Dynamic fixation eliminated the shear force between intramedullary nail and locked nail, prevented the nail from breaking and diminished the stress block between the fragments.

动力性固定消除了髓钉与锁钉间的剪力，有效防止了断钉，并消除了骨折端的应力遮挡；

互联网摘选

Slide-resistant pile program has realized these fuctions which are given slip surface count internal friction angle, given the shape of sliding surface design calculation, given the landslide thrust design calculation of landslide, given sliding surface moment, shear force design calculation. 5.

抗滑桩程序设计，实现了对给定滑动面形状反算内摩擦角、给定滑动面形状进行设计计算、给定滑坡推力进行设计计算以及给定滑动面处弯矩、剪力进行设计计算的功能。

互联网摘选

Experimental Research on Oblique Shear Force of Different Strength Reinforced Frame Column with Different Stirrup Areas

斜向水平荷载作用下不等肢不等强度配箍钢筋混凝土框架柱试验研究

互联网摘选

This method can not only be used to draw shear force diagram quickly, but also to determine the shear sign automatically, and to verify the reaction force of multi-span beam.

该方法不但能快速绘制剪力图，而且自动确定剪力符号，兼可对多跨梁的支座反力进行校核。

互联网摘选

The plot of the Shear Force Diagram and Bending Moment Diagram is not only important but also difficult for the students to learn in the course of Mechanics of Materials. The Graphic Method introduced in the paper is easy for students to master.

绘制剪力图和弯矩图是《材料力学》课的重点和难点，用本文论述的图解法作梁的剪力图和弯矩图学生易于掌握。

互联网摘选

The vertical beam shear and the bending force calculation; The Plotting of the Shear Force Diagram by the Graphic Method

用图解法作梁的剪力图和弯矩图

互联网摘选

results show that if change the number of sliding isolation bearings, the isolation effect will change. after setting more sliding isolation bearings, the period becomes longer, the interlayer displacement, absolute acceleration and shear force are all amplified.

结果表明，改变滑移隔震支座的数量，隔震效果明显不同，滑移隔震支座设置越多，结构的周期越长，层间位移幅值、绝对加速度和层间剪力的反应也随着增大。

互联网摘选