1、

The dynamic equation of arm rotating joint was established based on Lagrange equation. The relationship between torque and rotation angle of the arm rotation joint were obtained.

应用拉格朗日方程建立起摆臂旋转关节的动力学方程,得出摆臂旋转关节处的转矩与摆臂转角之间的关系。

互联网摘选

2、

The results also show that the dip angle of the joint determines the slope safety factor and the potential slip range. The steeper joint sets affect less the slope stability.

节理倾角与边坡安全系数、潜在滑动范围密切相关,陡倾角节理对边坡稳定性影响较小。

互联网摘选

3、

Influence of knee lateral thrust gait to femorotibial angle and lateral joint space in the knee varus patients

膝外摆步态对膝内翻患者股骨-胫骨角及胫股关节外侧间隙的影响

互联网摘选

4、

Frictional angle of rock joint is quite an important parameters which is difficult to attain in civil engineering design and construction.

在土木工程设计和施工中岩石节理的摩擦角是一个相当重要的参数,该值的获取既费时又费力。

互联网摘选

5、

Relationship of the Angle of Knee Joint and the injure of Lower Leg

对膝关节夹角与下肢损伤关系的探讨

互联网摘选

6、

Predicting the angle of knee joint by support vector regression model In order to identify angle of knee joint, support vector regression model is proposed.

利用支持向量机自回归模型预测膝关节角度采用支持向量机自回归模型对膝关节角度进行辨识。

互联网摘选

7、

Objective To investigate the influence and clinical significance of knee lateral thrust gait to femorotibial angle and lateral joint space in the patients with knee varus deformity.

目的探讨膝外摆(lateralthrust)步态对膝内翻患者股骨-胫骨角及胫股关节外侧间隙的影响及其临床意义。

互联网摘选

8、

Angle changes of shoulder joint. knee joint.

肩关节、膝关节和髋关节的角度变化。

互联网摘选

9、

Finally, with the ICR position and the data of AF, a nonlinear regression equation of rotation angle of ankle joint was established using variance analysis and nonlinear regressive method with poly variables.

再按照统计学原理,对所得瞬心位置和肌力臂数据进行方差分析,利用多元非线性回归方法最终建立了肌力臂与踝关节形态参数及关节角度的非线性回归方程。

互联网摘选

10、

According to the examples, the following simulation curves with time during the stance phase are obtained by calculation with Matlab 6.5: angle of each joint, contact length between the compliant foot and ground, the ground supporting force, and joint torques.

结合实例,用Matlab6.5计算和仿真了模型在着地阶段各关节转角、柔性脚与地面接触长度、地面支承力和关节力矩随时间的变化规律曲线。

互联网摘选

11、

There must be one or more universal joints to permit variations in the angle of drive. There must also be a slip joint that permits the effective length of the propeller shaft to change.

可轴向移动的球笼式万向节一个或几个万向节来适应传动角度的变化;一套伸缩花键,能够改变传动轴的现有长度。

互联网摘选

12、

In this paper, the accurate expression about the supplementary angle of gravity terrain correction at the joint of the circle and square domain was derived and presented.

本文给出了重力测量中地形改正的补角(园域和方域接口处)地改值的精确表达式。

互联网摘选

13、

X-ray Measurement of Dip Angle of Intervertebral Joint Surface

颈椎椎间关节面倾角的X线测量

互联网摘选

14、

The long frame bar and the short frame bar adopt the mutual complementary angle slope butt-joint.

所述的长框架条与短框架条采用互为余角的斜面对接。

互联网摘选

15、

Clinically, Q angle and generalized joint laxity were measured.

临床测量Q角和全身关节松弛度。

互联网摘选

16、

The most important link in the position control of robots is the control of angle of joint A. Therefor, utilizing fuzzy theory to study this kind problems is carried out.

关节角A的控制是机器人位置控制技术中至关重要的环节,为此研究了利用模糊原理对关节角速度控制的一类问题。

互联网摘选

17、

The results show that Q-angle is a spatial angle, which is increased with the knee joint flexion.

研究结果表明,Q角是一空间夹角,随屈膝角的增大而增大。

互联网摘选

18、

Results The angle of flexion of the MP joint before operation in group A is 37.30 ± 5.42 °, it increased 11.29 ± 2.36 ° and to 48.60 ± 2.98 ° when the bilateral collateral ligaments were cut, and there was significant difference.

结果A组,术前跖趾关节屈曲角度为37.30±5.42°,切断双侧侧副韧带后屈曲角度增加11.29±2.36°,达48.60±2.98°,与切断前比较差异有统计学意义(P0.01);

互联网摘选

19、

Methods CT scanning with tilt angle was performed in86 patients of normal sacroiliac joint.

方法分析近两年86例患者的正常骶髂关节CT资料。

互联网摘选

20、

Fractal dimension can be used to quantitatively describe jointroughbness and to and to estimate strength and friction angle of joint.

可以说,分维能定量地刻画节理的粗糙性,并有可能用来预测节理抗剪强度和节理摩擦角。

互联网摘选

  • 今日热词
  • 热门搜索

英语网英语词典(dict.25820.com)为您提供在线翻译英语词典单词大全英译汉汉译英等英语服务!可按单词字数词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈