Symmetric instability of non thermal wind balance basic flow

The courses of thermal stress and thermal deformation were analyzed by the FE method and the coefficients of thermal deformation for the wheel dimensions were obtained.

使用有限元方法分析了热轧车轮的热应力和热变形历程，得到了待求热轧车轮尺寸相应的热变形系数。

互联网摘选

The content included the temperature fields and thermal stress fields of wheel under emergency braking and grade braking.

本文分析了紧急、坡道两种制动条件下车轮温度场和热应力场的变化状态。

互联网摘选

In this paper the HAZ weld thermal cycles of the welding by both sides submerged arc welded steel pipe were reproduced by the dislocation overlap weld method.

采用焊道错位叠加方法，再现了螺旋管双面埋弧焊制管过程中内、外焊焊接热影响区（HAZ）的焊接热循环。

互联网摘选

As to the analysis of stress fields, on the basis of the thermal elastic dynamics, welding structure model is founded by coupling the temperature field and the stress field.

在随后的应力应变场分析过程中，通过热-力场间接耦合，在热弹塑性力学基础上，将温度场结果耦合如应力应变场，计算得到了焊后残余应力场。

互联网摘选

The thermal deformation in penetration welding with a laser has been investigated as a factor which results in the elevation on the surface of the weld.

研究了热变形对激光深熔焊焊缝表面形状的影响。

互联网摘选

Because the thermal elasto-plastic problem in welding is very complicated, it is too difficult to be dissolved by theoretic method.

由于焊接过程中的热弹塑性问题很复杂，所以理论分析十分困难。

互联网摘选

Application of finite element method to the analysis of axisymmetric thermal elasto-plastic stresses in welding

轴对称热弹塑性应力有限元分析在焊接中的应用

互联网摘选

Study on thermal circle under in-service welding condition

X70管线钢在役条件下的焊接热循环

互联网摘选

The Programed Control System of the Thermal Simulator HRM for Welding Research

HRM焊接热模拟试验机的程序控制系统

互联网摘选

The research reveals that the hi-frequency welding process not only causes the difference between the structure of the metal under the thermal effect by welding and the structure of the base metal, but also makes changes of orientation and continuity of the metal flow line in the steel;

研究结果表明：高频焊接过程除造成焊接热影响区与基体的组织差异外，还改变了钢中金属流线的方向和连续性；

互联网摘选

It is a problem for welding when there are requirements on the temperature field of high thermal conductivity alloy welding. In this paper, In this paper, copper alloy as an example of a high thermal conductivity, such as plasma arc welding of the pilot study.

对温度场宽度有要求的铜合金的焊接一直是焊接的难点之一，本文以铜合金为例进行高导热合金的等离子弧焊接性能的试验研究。

互联网摘选

Because of high thermal conductivity, welding of copper and its alloys is usually difficult by conventional fusion welding processes. The heat input required is much higher than that in almost other materials, and the welding speed is quite low.

由于铜及其合金具有很高的导热系数，使用传统的熔焊方法焊接通常是很困难的，焊接过程中需要很高的能量输入，而且焊接速度较低。

互联网摘选

At the same time, analyse the stress in barrel wall ( including curve stress, thermal stress and welding heat stress and restrict stress) and educe the formula.

同时，对回转窑筒壁应力，包括弯曲应力、温度应力、焊接温度应力和拘束应力进行了分析研究和公式推导。

互联网摘选

Based on this reason, a direct coupled-analysis model was built to simulate the thermal distributions of welding process of the tube.

对此，文中建立了考虑接触热传导的小截面薄壁方管并行焊接的直接耦合分析模型。

互联网摘选

Therefore, the simulation system which simulates the welding thermal process, welding residual stress and strain of typical aircraft components has been designed.

为此，本文设计了典型飞机构件焊接热过程/应力/应变模拟系统，协助焊接工程师完成实体建模、网格划分、焊接工艺过程设计及焊接过程模拟仿真。

互联网摘选

Effect of the Thermal Cycle of Welding Shrinkage Hole on Microstructure and Properties of Heat-Affected Zone Austempered Ductile Iron

焊补缩孔热循环对奥-贝球铁HAZ组织与性能的影响

互联网摘选

A mathematic model of transient thermal process in welding is established to simulate the moving of the heat source.

建立了焊接瞬态温度分布数学模型，解决了焊接热源移动的数学模拟问题；

互联网摘选

Measurement of thermal displacement of welding points for differental metals by laser speckle photography

激光散斑照相法测量不同金属材料焊接部位的热位移

互联网摘选

The Measurement of Weld Thermal Cycle in Welding by Both Sides SAW Spiral Pipe

螺旋管双面埋弧焊焊接热循环的测定

互联网摘选

Computation of thermal conductivity during welding by inversion method

焊接过程热传导系数反演法

互联网摘选