Because the thermal elasto-plastic problem in welding is very complicated, it is too difficult to be dissolved by theoretic method.

Application of finite element method to the analysis of axisymmetric thermal elasto-plastic stresses in welding

轴对称热弹塑性应力有限元分析在焊接中的应用

互联网摘选

Study on thermal circle under in-service welding condition

X70管线钢在役条件下的焊接热循环

互联网摘选

The Programed Control System of the Thermal Simulator HRM for Welding Research

HRM焊接热模拟试验机的程序控制系统

互联网摘选

The research reveals that the hi-frequency welding process not only causes the difference between the structure of the metal under the thermal effect by welding and the structure of the base metal, but also makes changes of orientation and continuity of the metal flow line in the steel;

研究结果表明：高频焊接过程除造成焊接热影响区与基体的组织差异外，还改变了钢中金属流线的方向和连续性；

互联网摘选

It is a problem for welding when there are requirements on the temperature field of high thermal conductivity alloy welding. In this paper, In this paper, copper alloy as an example of a high thermal conductivity, such as plasma arc welding of the pilot study.

对温度场宽度有要求的铜合金的焊接一直是焊接的难点之一，本文以铜合金为例进行高导热合金的等离子弧焊接性能的试验研究。

互联网摘选

Because of high thermal conductivity, welding of copper and its alloys is usually difficult by conventional fusion welding processes. The heat input required is much higher than that in almost other materials, and the welding speed is quite low.

由于铜及其合金具有很高的导热系数，使用传统的熔焊方法焊接通常是很困难的，焊接过程中需要很高的能量输入，而且焊接速度较低。

互联网摘选

At the same time, analyse the stress in barrel wall ( including curve stress, thermal stress and welding heat stress and restrict stress) and educe the formula.

同时，对回转窑筒壁应力，包括弯曲应力、温度应力、焊接温度应力和拘束应力进行了分析研究和公式推导。

互联网摘选

Based on this reason, a direct coupled-analysis model was built to simulate the thermal distributions of welding process of the tube.

对此，文中建立了考虑接触热传导的小截面薄壁方管并行焊接的直接耦合分析模型。

互联网摘选

Therefore, the simulation system which simulates the welding thermal process, welding residual stress and strain of typical aircraft components has been designed.

为此，本文设计了典型飞机构件焊接热过程/应力/应变模拟系统，协助焊接工程师完成实体建模、网格划分、焊接工艺过程设计及焊接过程模拟仿真。

互联网摘选

Effect of the Thermal Cycle of Welding Shrinkage Hole on Microstructure and Properties of Heat-Affected Zone Austempered Ductile Iron

焊补缩孔热循环对奥-贝球铁HAZ组织与性能的影响

互联网摘选

A mathematic model of transient thermal process in welding is established to simulate the moving of the heat source.

建立了焊接瞬态温度分布数学模型，解决了焊接热源移动的数学模拟问题；

互联网摘选

Measurement of thermal displacement of welding points for differental metals by laser speckle photography

激光散斑照相法测量不同金属材料焊接部位的热位移

互联网摘选

The Measurement of Weld Thermal Cycle in Welding by Both Sides SAW Spiral Pipe

螺旋管双面埋弧焊焊接热循环的测定

互联网摘选

Computation of thermal conductivity during welding by inversion method

焊接过程热传导系数反演法

互联网摘选

When laser power is lower, laser welding is belong to thermal conduction welding model; with the increasing of laser power, the surface happen to appear evaporation, then it transforms from thermal conduction welding model into deep penetration welding model.

当功率较低时，激光焊接属于热传导焊接模式；随着激光功率的提高，当工件表面刚好出现汽化时，则处于热传导焊接向深熔焊接过渡的临界状态。

互联网摘选

The laser-TIG hybrid heating source heats the steel by a similar thermal conductivity welding way, and this will keep the melting metals of Mg, Ni, Fe a metastable state.

激光-TIG电弧复合热源在钢板上以类似于热导焊的焊接模式熔化母材，使得熔池中熔化的金属Mg、Ni以及Fe处于一种亚稳态。

互联网摘选

Coatings of thermal sprayed welding, WC and Cr-WC particles distributed in the Ni-based alloy by the embedded ways. Binding state of Coating and matrix was metallurgy.

在热喷焊涂层中，WC和Cr-WC粒子呈嵌入式分布在Ni基合金中，涂层与基体的结合状态为冶金结合，表面形貌来看，涂层表面比较粗糙，大颗粒的WC粒子很清晰。

互联网摘选

Plasma arc thermal spray welding is a kind of surface harden engineering by taking plasma arc as themal resource and certain alloy power as additive.

等离子弧热喷焊技术是一种以等离子弧为热源，以一定成分的合金粉末作为填充金属的表面强化技术。

互联网摘选

Surface Reinforcement of the Mould for Pressing the Eyeglass by Thermal Spray Welding

镜片压制模具的热喷焊表面强化

互联网摘选

Elementary Introduction to the Application of Thermal Spray Welding Technique in Boiler Membrane Water Cooled Wall

浅议热喷焊在锅炉膜式水冷壁中的应用

互联网摘选