torsional rigidity

Then, it introduces CAD model into the finite element software, and accurately calculates bell crank rigidity and fillet stress concentration factor, which is used to analyze subsequent torsional vibration and strength.

将CAD模型导入有限元软件，计算求取准确的曲拐刚度及圆角应力集中系数，用于后续扭振及强度分析。

互联网摘选

Heavy lift vessel is one kind of special ships developed from the muti-purpose vessel. The entire ship inherently possesses low torsional rigidity due to its large opening deck structural configuration.

重吊船是从多用途船中发展出来的一种特殊船型，由于其结构上的特殊性&甲板大开口，使得整船的扭转刚度严重削弱，远低于常规型船舶。

互联网摘选

This article simpler introduced torsion pendulum's parameters, and practical tested torsional rigidity of slivers.

本文简单介绍了测量条子抗扭刚度的扭摆仪及其特点, 并实际测量了几种常见条子的抗扭刚度.

互联网摘选

The points out that the following should be followed to reduce tire wear: ensure tire normal air pressur and normal allowable tire load, assure optimum front wheel alignment parameters, design rational steering mechanism, increase integral torsional rigidity of the truck and its body.

指出，为减少轮胎磨损，应从以下几方面着手：保证轮胎正常行驶气压及允许裁荷、寻找最优前轮定位参数、设计合理的转向机构、提高整车和车箱的整体扭转刚度。

互联网摘选

Thin-walled bar with closed profile has the advantage of stronger torsional rigidity and can display the performance of characteristic of materials fully, therefore, it obtains the widespread application in the practical engineering.

闭口薄壁杆由于扭转刚度大，且能充分发挥材料性能，因而在实际工程中得到广泛应用。

互联网摘选

Analysis of local warping and torsional rigidity of spot-welded thin-walled box section beam with different wall thickness

异壁厚点焊箱形截面薄壁梁的局部翘曲和扭转刚度分析

互联网摘选

Based on some principal theories of control engineering, the mathematical expressions between the torsional rigidity of the torsional bar and the main dynamic characteristics of the Shaft-Mounted Tilting System in Converter are derived in this paper.

本文在控制工程有关的一些基本理论基础上，导出扭力杆扭转刚度与全悬挂转炉倾动系统主要动力学特性间关系的数学表达式。

互联网摘选

With the drill spiral groove length increases the torsional rigidity will down.

钻头螺旋槽长度的增加会导致钻头的扭转刚度下降。

互联网摘选

A plain weave weaving model at cloth-fell, where the torsional rigidity of pick is assumed to have a finite value, is developed.

本文在假设纬纱的抗扭刚度为有限值的基础上，建立了平纹织物在织口处组织单元的数学模型。

互联网摘选