static stress

According to the condition of static equilibrium and deformation compatibility and broad sense Hook's law, we have inferred formulas to calculate longitudinal and transversal internal force and stress for U-shaped trough shell with horizontal tension bar.

本文根据静力平衡条件、变形相容条件及广义虎克定律，推导出带拉杆U形壳槽纵、横向内力与应力的计算式。

互联网摘选

The static stress test verifies the correctness of the model.

最后通过静态应力试验验证该模型的正确性.

互联网摘选

A method of using Finite Element Method to study the static stress of the bus and dynamic performance is discussed fundamentally.

本文以客车车身骨架为主要对象，针对某客车半承载式车身进行有限元分析与研究，采用有限元法对车身进行全面的静态分析，对采用有限元方法研究整车动态性能作了初步探讨。

互联网摘选

This study was designed to establish three-dimensional reconstruction and the finite element model of the foot from the CT data and to study finite element stress of the tarsometatarsal joints in quasi-static load.

本研究旨在通过CT数据来对人足主要结构进行三维重建建立有限元模型，对跗跖关节进行准稳态有限元受力分析。

互联网摘选

The failure pattern of rock specimen subjected to dynamic loading is similar to that under static loading when the amplitude of stress wave is relatively low.

数值模拟表明：应力峰值较小时，试样的破裂模式与静态载荷作用下的破裂模式相似；

互联网摘选

The model of the aluminum alloy wheel classified as 16 x 6.57 is built. Static stress analysis is carried out to study the influence of bolt pre-tension, centrifugal force and the cornering force to the structural as well as the distributing rule of stress and strain.

首先根据试验工况建立起16×6.5J车轮的有限元模型，通过静力分析研究螺栓预紧力、旋转离心力和试验弯矩对车轮结构强度的影响以及车轮结构的应力应变分布规律。

互联网摘选

In order to verify the analysis results, static test on two spatial full-sized solid models is carried out, and the step-by-step load apply system is adopted to find out the stress and strain value of each testing point.

为验证计算分析结果，对两个受力较大的铸钢节点进行了足尺实体静力试验，采用分级加卸载制度获取各级荷载下各观测点应力应变值。

互联网摘选

The results show that no stress corrosion cracking in U shape samples is found and average static uniform corrosion rate is less than 2 mg/ dm 2 after testing in high temperature borated water for 5 000 h.

试验结果表明：在高温含B水中，U型试样试验5000h后无应力腐蚀破裂，静态月平均腐蚀速率小于2mg/dm2。

互联网摘选

The low-cycle fatigue procedure of steel 20 was investigate in 300 MPa static tension stress.

研究了20钢在300MPa静拉应力作用下的低周疲劳过程。

互联网摘选

It is justified that the maximum cyclic shear effect plane of the specimens in triaxial liquefaction test and-simple shea'r liquefaction test and of soil elements under general plane strain condition can only be determined by static stress components and is undependent on cyclic stress.

对于三轴液化试验、简切液化试验的受力条件和平面应变状态下土单元的受力条件，证明了最大往返剪切作用面的位置只由静力有效应力分量来确定而与往返应力无关。

互联网摘选

Wenchuan, Sichuan, earthquake and analyze the dynamic and static stress triggering effects on seven strong aftershocks.

0巨震在其强余震断层面上产生的完全库仑破裂应力变化, 分析了该变化对强余震的动态和静态应力触发作用.

互联网摘选

The strain response of the polymers by the temperature change under static stress

静应力下聚合物材料对温度变化的应变响应

互联网摘选

This paper describes a simplified method for calculation of box-section girder composed of thick plates under wheel pressure acting at cantilever part of its bottom flange, welding technology used. as well as approximate distribution of static stress, residual ones and its fatigue performance.

本文介绍了轮压作用在下翼缘外伸悬臂板上的厚板焊接箱形梁的简化计算方法、施焊工艺以及该梁的静力、疲劳性能和焊接残余应力的分布概况。

互联网摘选

Simulation Form Research for Rivet Connection and Static Stress Analysis on the Frame of Heavy Truck

重卡车架铆接模拟方式研究及结构静态强度分析

互联网摘选

And the results of the static stress were applied on the analysis of seismic reaction.

随后把计算得到的静应力状西安理工大学工程硕士学位论文态用于地震反应分析的初始应力场中。

互联网摘选