static stress的例句大全

The model of the aluminum alloy wheel classified as 16 x 6.57 is built. Static stress analysis is carried out to study the influence of bolt pre-tension, centrifugal force and the cornering force to the structural as well as the distributing rule of stress and strain.

首先根据试验工况建立起16×6.5J车轮的有限元模型，通过静力分析研究螺栓预紧力、旋转离心力和试验弯矩对车轮结构强度的影响以及车轮结构的应力应变分布规律。

互联网摘选

Simulation Form Research for Rivet Connection and Static Stress Analysis on the Frame of Heavy Truck

重卡车架铆接模拟方式研究及结构静态强度分析

互联网摘选

conclusion: the stress distribution of pelvis and displacement of units loaded under static stress are analyzed helpfully to clinically choose the internal fixation point for pelvic fracture and further ascertain the stress distribution of pelvis.

结论：分析静载荷作用下骨盆各部位应力分布以及骨盆各个单元在应力作用下的位移变化，有助于临床上进行骨盆损伤内固定力点的选择以及进一步明确骨盆内在应力值分布。

互联网摘选

It is justified that the maximum cyclic shear effect plane of the specimens in triaxial liquefaction test and-simple shea'r liquefaction test and of soil elements under general plane strain condition can only be determined by static stress components and is undependent on cyclic stress.

对于三轴液化试验、简切液化试验的受力条件和平面应变状态下土单元的受力条件，证明了最大往返剪切作用面的位置只由静力有效应力分量来确定而与往返应力无关。

互联网摘选

And the results of the static stress were applied on the analysis of seismic reaction.

随后把计算得到的静应力状西安理工大学工程硕士学位论文态用于地震反应分析的初始应力场中。

互联网摘选

The strain response of the polymers by the temperature change under static stress

静应力下聚合物材料对温度变化的应变响应

互联网摘选

This paper describes a simplified method for calculation of box-section girder composed of thick plates under wheel pressure acting at cantilever part of its bottom flange, welding technology used. as well as approximate distribution of static stress, residual ones and its fatigue performance.

本文介绍了轮压作用在下翼缘外伸悬臂板上的厚板焊接箱形梁的简化计算方法、施焊工艺以及该梁的静力、疲劳性能和焊接残余应力的分布概况。

互联网摘选

conclusion: analyzing the stress distribution of acetabulum and units displacement when static stress loaded, which can provide internal fixation point for acetabular fracture treatment and try to understand the stress distribution of acetabulum.

结论：静载荷作用下髋臼各部位应力分布以及髋臼各个单元在应力作用下位移变化，有助于临床上进行髋臼损伤内固定力点的选择。

互联网摘选

in this paper, the static stress field and dynamic stress field in gas bearing coalseam under the condition of disclosing coal seam in a cross cut are derived with mathematic analysis.

本文用数学解析方法解出了石门揭煤条件下工作面前方含瓦斯煤体内的稳态应力场和动态应力场。

互联网摘选

The static stress test verifies the correctness of the model.

最后通过静态应力试验验证该模型的正确性.

互联网摘选

Wenchuan, Sichuan, earthquake and analyze the dynamic and static stress triggering effects on seven strong aftershocks.

0巨震在其强余震断层面上产生的完全库仑破裂应力变化, 分析了该变化对强余震的动态和静态应力触发作用.

互联网摘选

through a static stress analysis for the improved model, the optimization program was proved economical and feasible.

对改进后的模型进行应力校核，证明了本优化方案的经济性和可行性。

互联网摘选

A method of using Finite Element Method to study the static stress of the bus and dynamic performance is discussed fundamentally.

本文以客车车身骨架为主要对象，针对某客车半承载式车身进行有限元分析与研究，采用有限元法对车身进行全面的静态分析，对采用有限元方法研究整车动态性能作了初步探讨。

互联网摘选

By slip circle analysis and analysis of stress-strain with FEM, the static stability of ash dams has been analyzed.

渗流过程中灰坝坝体的静力稳定，此过程中分别采用了规范规定的圆弧滑动法和有限元应力应变分析，使两者能够相互验证；

互联网摘选

At last combining the project example, the static and kinetic friction coefficients of the sliding floor materials were measured through experiments, and the temperature stress produced by temperature difference was computed with the FEA method.

结合工程实例，由实验测得滑动层材料的静、动摩擦系数，运用有限元方法计算了温差引起的温度应力。

互联网摘选

A static analysis of the No. 2 leg-cone of a tricone bit is conducted by the finite element method, and the distribution pattern of the contact stress on the leg journal and thrust surface with different bearing clearances is worked out.

用有限元法对某型三牙轮钻头的2号牙轮－牙爪进行了静力计算，求得不同轴承间隙时牙爪轴颈及止推面上的接触应力分布规律。

互联网摘选

This paper introduced hydraulic expansion sleeves ( static pressure expansion arbor) which clamp disk milling cutter and clamp stress locking cutting tool-holder.

介绍了夹持片状盘铣刀的液压轴套（静压膨胀芯轴）和夹持指状铣刀的应力夹紧式刀具夹头。

互联网摘选

To sustain a larger wheel on the static and dynamic load, assembly stress, brake shoe, brake pad brake thermal stress and centrifugal force through the curve and so on.

轮对需要承受较大的静载荷和动载荷、组装应力、闸瓦、闸片制动时产生的热应力以及通过曲线时的离心力等。

互联网摘选

Research on Thermal Stress Equivalent Static Load for Shell under Effect of Constant Temperature Field

常量定常温度场作用下壳体热应力当量静载的试验研究

互联网摘选

Tectonic force source and seismic source stress field investigation on the coating's static shear stress and surface tension

构造力源和震源应力场涂料静切力及表面张力的研究

互联网摘选