pressure inlet

The experimental device on the performance of vortex tube is designed, and its cooling performance affected by inlet pressure p0 and cooling air ratio μ is investigated.

针对进气压力p0、冷气流率μ对其冷却性能的影响进行了试验研究。

互联网摘选

The simulation results of inlet air manifold show that the uniformity of the velocity at outlet of the manifold are improved by using the appropriate bell-mouthed inlet and clipper-built baffle, and inlet pressure needed of the manifold decrease.

对进气箱的模拟结果表明，采用扩压型进口加流线型挡块的方案可以提高出口速度的均匀性，同时降低了进气箱入口所需的气体压力。

互联网摘选

The water diversion system of the hydropower station will convey water from regulation pond to the power house through water inlet. The main buildings include water inlet, water diversion tunnel, surge tank, pressure shaft and adits with the total length of 3. 5km.

电站引水系统由进水口从调节池中引水到厂房，主要建筑物包括进水口、引水隧洞、调压井、压力竖井和平洞，全长约3.5km。

互联网摘选

The loop uses high-temperature helium as the thermal source and in full scale to simulate the 30% generator load for two-phase flow stability verification test under various conditions: inlet sub-cooling degree, outlet steam pressure, flow rate and inlet resistance.

实验系统用高温氦气作为热源，采用1∶1全尺寸模拟，进行了30%负荷工况两相流稳定性验证实验、入口过冷度、蒸汽出口压力、流量及入口阻力对两相流稳定性影响的研究。

互联网摘选

In the paper, Inlet pressure effects on the thermohydrodynamic performance of a thrust bearing are investigated theoretically.

从理论上研究了进口压力对推力轴承热动力润滑性能的影响。

互联网摘选

Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.

通过从最大进口压力减去所需要的出口压力来计算压差.

互联网摘选

Through the use of an experimental method the influence of inlet water temperature on the shock wave pressure rise characteristics of steam water two phase flows has been investigated.

采用实验方法研究了进水温度对汽液两相流激波升压特性的影响。

互联网摘选

The Calculation of the Temperature Equilibrium and the Shaft Center Trajectory for a Dynamically Loaded Journal Bearing(ⅱ)& Nonzero Inlet Pressure

动载轴承温度平衡和轴心轨迹计算（Ⅱ）&进油压力不为零的情况

互联网摘选

A higher pressure of the inlet fluid will result in the increases of thermo-elastic deformation and the balancing film thickness.

流体注入压力越高，热弹变形量越大，密封端面平衡间隙亦越大。

互联网摘选

Otherwise, the air exhauster is not necessary, and the air inlet ( 4) connecting with the high-pressure clean air is arranged in the air inlet pipeline.

或不用抽气机，而在进气管道有一接高压清洁空气的进气口（4）。

互联网摘选