morphologies

The morphologies of copolymer c-PEO-g-PS in water were observed and the diameter of spheric micelle was about 200 nm.

并对该共聚物在水中形成的胶束，用透射电镜进行形态的观测，所形成球形的胶束粒径在200nm左右。

互联网摘选

A Study of Morphologies of Residual Austenite after Laser Transformation Hardening

激光相变硬化后的残余奥氏体分析

互联网摘选

The morphologies, phase structures and abrasive mechanism of nitrided layer were investigated with optical microscope, SEM and X-ray diffraction analysis.

利用金相、X射线衍射分析、扫描电子显微镜等手段研究了渗氮层的组织、相组成及其磨损机理。

互联网摘选

By analyzing 3D surface morphologies and temperature field of dry sliding friction, the reason why vermicular iron has excellent dry sliding friction properties was further explained from the behaviour mechanism.

通过对试样三维表面形貌和干滑动摩擦温度场分析，进一步从机理上解释了蠕墨铸铁所具有的良好干滑动摩擦学性能。

互联网摘选

The morphologies of several polyfluoroethylene oils were studied by small angle laser light scattering.

本文用激光散射及偏光显微镜等技术剖析了几种氟油的聚集态结构.

互联网摘选

At700C, ZnO nanostructures with tetrapod-like and wire-like morphologies were synthesized using thermal evaporation method.

利用热蒸发方法制得四角状和线状氧化锌纳米结构。

互联网摘选

A new determing technique has been developed via the electrochemical sensor modified by HAp assemblies with unique morphologies. The relationship between microstructure and the electrochemically sensing capability has also been researched, mainly attributes to the effect to the electro-catalytic kinetics.

发展了具有特异形貌羟基磷灰石晶簇修饰下的电化学传感器的检测技术，并研究了晶簇形貌和微结构对于其电化学传感性能的关系，主要是对于电催化过程动力学的影响。

互联网摘选

Synthesis of CaCO_3 Crystals with Special Morphologies in the Presence of Malic Acid

苹果酸作用下特殊形貌CaCO3晶体的合成

互联网摘选

It is found that, with the number of lipid molecules increasing ( from 100 to 576), three kinds of morphologies were observed: spherical micelle, disc micelle and vesicle.

模拟发现，随着磷脂分子数目的增加（从100到576），依次形成三种平衡态结构（球形胶束、盘状胶束和囊泡）。

互联网摘选

And the intergranular morphology , the polygonal morphology and the fan-cleavage morphology are the main fracture morphologies.

“缝隙”和“孔洞”是其断口最主要的微观缺陷形貌特征.

互联网摘选

The directionally solidified Tb-Dy-Fe magnetostrictive alloys with < 110> orientation were prepared in a velocity range from 30 to 720 mm/ h, and the solidified morphologies change from planar, cellular to dendritic with increasing growth velocity.

采用区熔定向凝固方法，在30-720mm/h生长速度范围内，均能获得（110）轴向择优取向生长的Tb-Dy-Fe合金；凝固形态随生长速度提高出现从平面晶到胞状晶、树枝晶转变；

互联网摘选

There are different fibril morphologies on the different zones of injection-molded samples.

在注塑成型样品的不同区域,纤维的形态也不尽相同.

互联网摘选

Besides, a series of experimental observations were conducted for fully understanding the pore scale water morphology, distribution and evolution in porous media and results revealed that there is some certain inherent relationship between the thermal conductivity measurement relative error and pore water morphologies.

利用实验测量堆积型多孔介质在不同含湿率时的导热系数，并深入观察和认识孔隙内水分形态、分布及加热时水分演化过程，揭示其与导热系数测量相对误差之间的内在联系。

互联网摘选

By using scanning electric microscope ( SEM ) , the morphologies of the impact fracture section were analyzed.

并通过扫描 电镜 观察冲击断面, 研究共混物的形态结构与材料性能的关系.

互联网摘选

The FT-IR of the water pool is investigated. The different diversity morphologies are characterized by TEM.

考察了不同水核的红外光谱图,利用透射电镜,观察到了铟纳米粒子的不同分散形态.

互联网摘选

Effect of Laser Energy Density on SiC Whisker Morphologies by In-situ Growth

激光能量密度对原位生长碳化硅晶须形态的影响

互联网摘选

The experiment results show that the effect of superheating temperature on secondary dendrite spacing is unnoticeable when Al-7% Si alloy is superheated in the temperature range of 750-1 100C. Dendrite morphologies become well distributed with the increase of superheating temperature.

实验结果表明：亚共晶Al-7%Si合金在750-1100℃进行熔体温度处理时，过热温度对二次枝晶的细化作用不明显，而组织的均匀性随着过热温度的升高而变好；

互联网摘选

The kinds and morphologies of intermediate products obtained during this thermal decomposition process were investigated using integrated thermal analysis, X-ray diffraction, scanning electron microscope, energy dispersive X-ray spectrum and chemical analysis.

采用热重分析、X射线衍射、扫描电镜、能谱分析和化学分析等方法研究中间产物及其形貌。

互联网摘选

The positive feedback between fluid flow and dissolution reaction leads to complex reaction front morphologies and has important influence on in-situ leach mining.

流体流动与溶解反应的正反馈作用可导致复杂的反应前锋形态并对原地溶浸开采有重要影响。

互联网摘选

By use of combined self-propagating high-temperature synthesis, induction melting with investment casting, in-situ TiB reinforced titanium matrix composite is fabricated in Ti-B-Al system. Phase identification and reinforcement morphologies are performed with XRD, SEM and TEM.

采用自蔓延高温合成（SHS）、感应熔炼和熔模精铸相结合的方法，利用Ti-B-Al体系制备出了原位自生TiB增强的钛基复合材料。

互联网摘选

Stromatolite morphologies and their terrigenous sediment association indicate depositional basin tectonic setting.

叠层石的形态和它们与陆源沉积的关系反映了沉积盆地的构造背景。

互联网摘选

The simulative results showed that the solvent molecular size is one of the key factors that determine the morphologies of the copolymer aggregates.

模拟结果表明，溶剂尺寸是决定共聚物聚集形态的重要因素之一。

互联网摘选

The heredity of iron compound morphologies in Al alloys and spheroidizing mechanism

铝合金中Fe相形态的遗传性及球化机制的研究

互联网摘选

The nanosized titania with different crystal forms, morphologies and particle sizes was prepared by hydrothermal method.

水热法合成了不同晶型 、 形貌和大小的纳米二氧化钛.

互联网摘选

Fracture morphologies of TIG welds show that the fatigue fracture occurs from weld defects.

TIG焊接接头疲劳端口分析显示,焊接缺陷是主要的疲劳裂纹源.

互联网摘选

The deposition rate, morphologies, breakdown voltage and refractive index were studied.

研究了制备工艺对薄膜沉积速率 、 表面形貌 、 折射率和电击穿场强的影响.

网络文摘精选

The morphologies and the size of the nanoparticles were measured through transmission electron microscopy and dynamic light scattering, respectively, and the zeta potential was also measured.

通过透射电子显微镜、动态光散射表征了共聚物的形貌和粒径，并进行了Zeta电位测试。

互联网摘选

The Cu2O nanocrystals of different morphologies were prepared using hydrazine hydrate as the reducing agent.

采用不同的前驱物，以水合肼为还原剂制备了不同形貌的纳米Cu2O。

互联网摘选

Pores and density along the radial direction of the composite sample deposited at different temperatures were measured by means of Leica quantitative metallography and Archimedes principle methods. Morphologies and pores of the composites were observed by scanning electron microscopy.

用Leica定量金相分析仪及Archimedes排水法测定了不同沉积温度制备的样品沿径向的孔隙率及密度分布，同时用扫描电子显微镜观察了样品的低倍形貌及孔隙率分布。

互联网摘选

When ferrocene and thiophene were used together, the product morphologies were related to the thiophene content.

而二茂铁和噻吩同时使用时, 产物的形貌随噻吩浓度的不同而变化.

互联网摘选