rolling texture的例句大全

quantitative analysis of rolling texture in steel sheets

冷轧钢板变形织构的定量分析

互联网摘选

The annealing after hot rolling can weaken the orientation intensities of a-fiber texture of hot rolled sheet but strengthen the relative orientation intensities of y-fiber texture, lower texture gradient and promote the same oriented grains to distribute dispersively.

由于热轧后退火能显著弱化热轧板的α纤维织构，提高Y纤维织构的相对强度，显著降低织构梯度，提高各取向晶粒分布的均匀性。

互联网摘选

Texture evolution of semi-processed non-oriented silicon steel with temper rolling

半工艺无取向硅钢加临界变形的织构演变

互联网摘选

The Influence of Cold Rolling on the Formation of Recrystallization Texture in Titanium Sheet

冷轧形变量对钛板材再结晶织构形成的影响

互联网摘选

The effect of rolling reduction on the formation of texture in cold rolled and annealed titanium sheet has been in investigated by means of the crystallite orientation distribution function analysis ( CODF).

采用三维晶体学取向分布函数（CODF）分析法研究了工业纯钛板材不同冷轧形变量对织构形成的影响。

互联网摘选

Texture Simulation of Slip Deformation in FCC Metal of Cold Rolling

FCC金属滑移形变冷轧织构模拟

互联网摘选

Asymmetric rolling reduces recrystallization { 111} 112 component of center layer and fast roll side layers by weakening cold rolling a and y, resulting in the decrease of recrystallization { 111} 112 component generally. ( 4) a texture component.

{111}112织构组分&异步轧制通过减少冷轧α和γ，使快辊侧及中间层的再结晶{111}112组分降低，进而总体上减小111}112组分。

互联网摘选

Experimental results show that: texture division resulting from shear stress applied on the cross shear area can be eliminated in a double direction rolling process, and favorable deformation texture better than that of conventional rolled sheel may be obtained;

结果表明：双向轧制能有效地消除剪切应力导致织构组分偏离的影响，并获得比常规轧制板材更为理想的冷轧织构组态；

互联网摘选

Study of recrystallization texture of cold rolling aluminium alloy 3004

冷轧3004铝合金再结晶织构的研究

互联网摘选

The results showed that there was weak { 111} texture component in annealing texture of surface layer of 1.2 mm SPCC cold rolling sheet and { 111} texture which is available to increase deep-drawing property of steel was not found at center layer.

结果表明，1·2mmSPCC冷轧板退火织构表层有较弱的{111}织构组分，中心层没有发现有利于提高钢的深冲性能的{111}织构。

互联网摘选

By using optical metallography; TEM and x-ray diffractometer, microstructure and texture of 3004 aluminium alloy sheet from cast rolling plate are studied.

通过光学金相、透射电镜和x射线衍射技术等分析方法，研究了3004铝合金铸轧板的组织和织构特征。

互联网摘选

influence of lubricants on recrystallized cubic texture of high-purity aluminium foils during cold rolling

冷轧润滑剂对高纯铝箔再结晶立方织构的影响

互联网摘选

effect of rolling process on texture evolution of cold rolled non-oriented silicon steel

轧制条件对冷轧无取向硅钢织构的影响

互联网摘选

pit etching research about rolling and annealing treatment on texture in non-oriented silicon steel

蚀坑法研究冷轧及退火工艺对无取向硅钢织构演变的影响

互联网摘选

effect of hot rolling process on the microstructure and texture of non-oriented silicon steel

热轧工艺对无取向硅钢组织结构的影响

互联网摘选

rapid measurement of texture for cold rolling interstitial free steel sheets

无间隙原子钢冷轧板织构的快速检测

互联网摘选

Effect of cold rolling process on magnetic properties and texture of the finish products of double oriented silicon steel

冷轧工艺对双取向硅钢磁性和成品织构的影响

互联网摘选

Effects of temper rolling on the cubic texture formation in primary recrystallized electrical steel were investigated.

尝试了小形变量轧制对立方织构电工钢织构形成的影响。

互联网摘选