Effect of Thickness Ratio on Formability of Stainless Steel Cladding Aluminum Sheet

  • 厚度比对不锈钢覆铝板成形性能的影响
  • 来源:互联网摘选更新时间:2026-07-01 16:07:51

  • 重点词汇
  • thicknessn.层;浓度;厚(度);最厚的部分;
  • ofprep. 关于;属于…的;由…制成;
  • aluminumn.<美>铝;
  • ration.比,比率;比例;系数;
  • steeln.钢,钢铁;钢制品;兵器;钢铁工业;
  • effectn.影响;效果;所有物;特效;
  • onprep. (覆盖、附着)在…上;由…支撑着;在(运输工具)上;在(某一天);就在…之后;关于(事或人);(身上)带着;为(某团体或组织)的一员;吃;(表示方向)在,向,对;在,接近(某地);根据;以…支付;通过;与…相比
  • sheetn.床单;一页/张(纸);纪要;薄板;一层/团/片;拉帆绳;
  • claddingn.覆层;
  • 相关例句
1、

Influence of tension on Aluminum foil profile under large width to thickness ratio

张力对大宽厚比铝箔板形的影响

互联网摘选

2、

Research on Depth-thickness Ratio Check of walls With Constructional Columns

带构造柱墙的高厚比验算探讨

互联网摘选

3、

Study of the Optimal Thickness Ratio of the Birefringent Filter

双折射滤光片最佳厚度比的研究

互联网摘选

4、

A Further Study on Choosing Gear Lubricant Viscosity Based on Film Thickness Ratio

基于膜厚比选用齿轮润滑油粘度的再研究

互联网摘选

5、

Analyses of wall thickness ratio γ of pipe under stretch reducing

张力减径壁厚系数γ辨析

互联网摘选

6、

Tensile strength and stiffness increase as skin thickness ratio increases.

拉伸强度和硬度随外壳厚度比增加而增加。

互联网摘选

7、

Optimal layer thickness ratio for optimization of ceramic laminates

强界面陶瓷层状复合材料优化设计的最佳层厚比探讨

互联网摘选

8、

Two questions in height thickness ratio calculating

高厚比验算的两个问题

互联网摘选

9、

The design variables were linked with dimensionless design variables, so a design variable can control many elements with different thickness and the application range was extended.

采用无量纲设计变量实现变量连接,一个设计变量可以控制多个不同厚度的单元,扩大了程序的适用范围。

互联网摘选

10、

A brief introduction is made to the testing methods of dry and wet film thickness, and service range thereof.

简要介绍了干膜和湿膜的测定方法和使用范围。

互联网摘选

11、

On the basis of varied-direction seismic data ( including 3-D seismic data) from the downthrown side of the southern ZH fracture, an anomaly volume with large thickness and wide range, which is different from the surrounding seismic facies has been found on the Paleogene strata.

本文依据ZH地区A-2构造南断裂下降盘多个方向的地震资料(包括三维地震资料),发现在下第三系地层里存在一个厚度大,范围广,与周围地震相截然不同的异常体。

互联网摘选

12、

Samples having Cu barrier thickness in the range from 5 to 500 nm show Jc values about a factor of 40 higher for the current parallel to the long axis of the filaments than for the current perpendicular to the long axis.

对Cu层厚度为5到500nm的样品,当电流平行于细丝的长轴方向时、其临界电流约为电流垂直于细丝长轴方向时的40倍。

互联网摘选

13、

Then it is printed onto a high-alumina ceramics substrate by silk screen print method. A superconducting wire of thickness in the range of 20~ 30 μ m, and zero resistance temperature 82 K, was successfully obtained.

用丝网印刷-烧结工艺,在高铝陶瓷基板上制得了厚约20~30μm,零电阻温度82K的厚膜超导电带。

互联网摘选

14、

Al 2O 3+ SiO 2+ Fe 2O 3 is generally 80%  ̄ 82%. The formation of bauxite is apparently controlled by the karst paleo topography. The thickness has big range.

总体上讲,化学成分比较稳定,(Al2O3+SiO2+Fe2O3)一般为80%~82%,铝土矿的形成明显受岩溶古地形的控制,矿体厚度变化很大。

互联网摘选

15、

The Upper Paleozoic Carboniferous-Permian source rocks are mainly coal measure strata, with thickness in the range of 150~ 500m, low to medium organic matter abundance, and type ⅲ kerogen.

上古生界石炭&二叠系烃源岩主要为煤系地层,厚度为150~500m,有机质丰度属于低-中等,有机质类型为Ⅲ型。

互联网摘选

16、

When the similar plane wave propagation mode is used to measure, the variation of wall thickness in certain range have small influence to measurement results.

利用准平面波模式进行测量时,壁厚在一定范围内对测量结果影响并不很大。

互联网摘选

17、

In the test, the measured flame thickness and the range of variation are both larger than that calculated by static flame model.

在本实验条件下所测得的实际火焰厚度较厚,而且变化范围较大,其厚度比按传统的静态火焰模型计算出的结果大得多。

互联网摘选

18、

A method to detect surface roughness by reflected interference pattern of transparent ( or semitransparent) film is introduced, whose thickness testing range is from 0 2 micron to less than 20 micron.

介绍了用反射干涉频谱法测量透明或半透明薄膜表面平整度的方法,薄膜厚度的测量范围约在02~20μm(小于20μm)之间。

互联网摘选

19、

Middle-frequency melting, deformed process and final heat-treatment were used to prepare Pd-Ba alloy foil with thickness in range of 0.1~ 0.2 mm.

经过中频炉熔炼,压力加工以及热处理,制备了厚度尺寸范围0.10~0.20mm的Pd-Ba合金箔材。

互联网摘选

20、

The results show that in the initial stage of micro-arc oxidation the obtained ceramic coating is compact and nearly no microflaw can be observed, the microflaws like holes begin to appear in the exterior and finally irregular holes fill with 90% of the thickness range.

结果表明:微弧氧化初期,陶瓷层致密,几乎观察不到显微缺陷,随着处理时间的延长及陶瓷层的增厚,其外侧开始出现孔洞类缺陷,直至90%厚度范围布满相互交错的不规则孔洞;

互联网摘选

  • 今日热词
  • 热门搜索

英语网英语词典(dict.25820.com)为您提供在线翻译英语词典单词大全英译汉汉译英等英语服务!可按单词字数词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈