axial cross

Because great changes axial cross section, stainless steel tube joint is difficult to process.

不锈钢管接头截面积变化大, 成形和脱模困难.

互联网摘选

In comparison with 30 ° air inlet, the generated vortexes are fewer, weaker and nearer to the air inlets when the inlet angle is 45 ° along the axial cross section.

与30°进气道相比，沿轴向横截面上45°进气道所形成的回流区向进气道一侧偏移，回流区区域减少，强度减弱。

互联网摘选

Numerical study on the fire stability of the axial-compression cross-section column of reinforced concrete

钢筋混凝土十字形轴压柱耐火性能的数值模拟研究

互联网摘选

The phenomenon of longitudinal fission seldom occurred during the process of tube plug drawing mill compared with empty-sunken steel tube. The problem which seldom cause transverse fissure in form of partial failure owing to uniform distribution of axial stress in cross section.

与空拔相比较，在短芯棒拔制过程中，纵裂现象一般不会发生，由于钢管轴向应力在横截面上分布均匀，一般也不会出现以局部破坏形式出现的横裂现象。

互联网摘选

Study of the Inner Boundary Force of Axial Variable Cross Section Annulus Power Law Fluid

轴向变截面环空幂律流体内边界力的研究

互联网摘选

Angular calibration of radar antenna system is composed of the calibration of angular error sensitivities ( also called directional sensitivity), adjustment of cross-coupling of azimuth and elevation signals, and the calibrations of system errors such as antenna axial system error, dynamic delay and so on.

雷达系统天线的角度标校包括对系统角误差灵敏度（又称定向灵敏度）的标定、方位俯仰信号交叉耦合的调整以及对天线轴系误差、动态滞后等系统误差的标定。

互联网摘选

INQUIRY INTO DEFORMATION OF THE AXIAL SECTION IN CROSS ROLLING WITH HELICAL GROOVES AND INVESTIGATION OF ITS EXPERIMENT IN MOIRE METHOD Research on NC Grinding of Rotary Surface Parts with Arc Axial Section and Precision Controlling

螺旋孔型斜轧轴向断面变形的探讨及云纹实验研究圆弧轴截形回转面的磨削及精度控制方法的研究

互联网摘选

The experimental results showed that both the circumferential and axial stresses around the cross section varied in a similar "W" shape, but the former was larger than the latter in absolute valume.

实验结果表明，弯头横截面上的环向应力和轴向应力分布均呈相似的W型，但各点环向应力的绝对值均大于轴向应力。

互联网摘选

The specimen irradiated by intense laser generates distinct plastic deformation, and the profile of axial cross section of specimen after shocking is similar to a coniform figure.

结果表明：在强激光冲击下，试样发生显著的塑性变形，变形后轴截面形状为类圆锥形；

互联网摘选

Because great changes are happened on its axial cross section, stainless steel tube joint is difficult to process.

不锈钢管接头截面积变化大，成形和脱模困难。

互联网摘选

Research of Axial Thrust Force during Asymmetric and Cross Rolling

异步交叉轧制的轴向力研究

互联网摘选