tig

The varied weld penetration depths of austenic stainless steel A-TIG welding are studied.

采用活性化焊剂TIG焊接方法研究了奥氏体不锈钢焊缝熔深的变化.

互联网摘选

Development of Auto TIG Welding Power Source for All Position Welding

全位置自动焊管机TIG焊电源研制

互联网摘选

Technology of TIG in small drive thin wall stainless steel tube

细径薄壁不锈钢管的氩弧焊接工艺

互联网摘选

The-frequence oscillator used in TIG welding a serious interference source to the nearby electronic circuits.

TIG焊中采用的高频振荡器,是邻近电子电路的严重干扰源.

互联网摘选

A new type of maraging steel metal powder cored wire for die TIG surfacing is developed.

研制了一种用于TIG模具堆焊的马氏体时效钢金属粉芯焊丝.

互联网摘选

For the reasons , Ukraine Paton Welding Institute puts forward the method of A-TIG welding.

针对TIG焊的不足, 乌克兰的Paton焊接研究所首先提出了A -TIG 焊方法.

互联网摘选

Microstructure and Mechanical Properties of TIG Welded Joint of CLAM Steel

中国低活化马氏体钢TIG焊微观组织与力学性能的研究

互联网摘选

The varied weld penetration depths of austenic stainless steel in A-TIG welding are studied.

采用活性化焊剂tig焊接方法研究了奥氏体不锈钢焊缝熔深的变化.

互联网摘选

The laser-TIG hybrid heating source heats the steel by a similar thermal conductivity welding way, and this will keep the melting metals of Mg, Ni, Fe a metastable state.

激光-TIG电弧复合热源在钢板上以类似于热导焊的焊接模式熔化母材，使得熔池中熔化的金属Mg、Ni以及Fe处于一种亚稳态。

互联网摘选

A new Tig welding process with tailoring magnetic field was supposed according to magnetism len technique.

利用磁镜原理，设计了电磁复合场下的TIG振荡焊接工艺。

互联网摘选

Cold body TIG surfacing technology and mechanical property of copper alloy gland ring

铜合金密封环冷体TIG堆焊工艺及接头力学性能

互联网摘选

AFA 3G Gd Rod Top End Plug Girth TIG Wilding

AFA3G含钆燃料棒上端塞环缝TIG焊接研究

互联网摘选

A type of switched HF pulse TIG welding power source is introduced in this paper.

本文介绍一种开关式高频脉冲TIG焊电源.

互联网摘选

This paper introduces the TIG _ welding technology of repairing stainless steel casement.

介绍了不锈钢镶套的TIG焊接工艺.

网络文摘精选

Microstructure and Mechanical Properties of CLAM Steel in TIG Weld

CLAM钢TIG焊组织与性能的研究

互联网摘选

The crack analysis and the prevention measure for TIG welding of AZ 31 B magnesium alloys were studied.

分析了AZ31B镁合金TIG焊 接头裂纹形成机理,并提出了相应的预防措施.

互联网摘选

Compare with TIG welding, A-TIG welding had tangible result on elimination of gas holes.

与TIG焊相比, A-TIG焊 在消除气孔方面具有明显的作用.

互联网摘选

TIG has been used for root pass, self-shielded flux-core FCAW for fill and gap in light of the characteristics on the construction site.

根据现场施工特点，采用钨极氩弧焊根焊、自保护药芯焊丝半自动焊填充、盖面。

互联网摘选

Study on the heat treatment of CLAM steel joined by TIG

CLAM钢TIG焊后的热处理工艺研究

互联网摘选

Abstract: This paper introduces the TIG-welding technology of repairing stainless steel casement.

文摘: 介绍了不锈钢镶套的TIG焊接工艺.

互联网摘选

According to detection of TIG welding pool by optical sensor, through adjustment of pulse width of welding current peak value and base value by single-chip computer, the principle and method of penetration control of peripheral welds of cylinders was introduced in this paper.

本文介绍了采用光电传感器检测TIG焊缝熔透状况。通过单片机对脉冲焊接电流峰值及基值宽度的调节，控制圆筒形管环焊缝熔深的原理及方法。

互联网摘选

Influence of Welding Parameters on Single-Component A-TIG Weld Formation

焊接规范对单组分活性剂A-TIG焊焊缝成形的影响

互联网摘选

It also analyzes the welding technology characteristics of inverter pulse TIG welding machine.

分析了逆变式脉冲TIG焊机的焊接工艺性能.

互联网摘选

The low surface tension and low viscosity of aluminum alloys are the reason that the change of surface tension temperature gradient is not the main mechanism of activating flux increasing weld penetration of activating TIG welding.

而铝合金材料表面张力小，粘度低，是导致表面张力温度梯度改变不是活性剂增加铝合金活性TIG焊熔深的主要机理的重要原因。

互联网摘选

The dynamic change of the molten pool influences the quality of welding joint directly in TIG.

TIG焊接 过程中,熔池的动态变化直接影响焊接质量.

互联网摘选

As a-quality welding process, TIG welding in the field of welding has been widely used.

作为一种优质的焊接工艺, TIG焊在焊接领域得到了广泛使用.

互联网摘选

The results show that after 45h of cavitation erosion test, the mass loss of the specimen with ground surface was 1.57 times of that with TIG remelted surface.

结果表明：在45h空泡腐蚀试验后，磨削试样的累积失重量是TIG表面重熔试样的1.57倍；

互联网摘选

For the reasons, Ukraine Paton Welding Institute puts forward the method of A-TIG welding.

针对TIG焊的不足，乌克兰的Paton焊接研究所首先提出了A-TIG焊方法。

互联网摘选

A microchip controlled double pulsed variable polarity TIG welding power supply is designed.

研究设计了基于单片机控制的双脉冲混合调制变极性TIG焊接电源 .

网络文摘精选

Fracture morphologies of TIG welds show that the fatigue fracture occurs from weld defects.

TIG焊接接头疲劳端口分析显示,焊接缺陷是主要的疲劳裂纹源.

互联网摘选