snubber

The influence of the fall rate of anode current and snubber resistor on anode spike voltage was emphatically analyzed, on the basis of the relation between anode spine voltage and outer chat parameters, and ample experimental verification is given in this paper.

本文在GTO尖峰电压与外电路各参数关系的基础上，分别着重分析了阳极电流下降率和缓冲电路电阻对尖峰电压的影响，并给予了无分的实验验证。

互联网摘选

Figure 44 shows the same OUTPUT response with the snubber in place.

如图44所示,是配以适当的缓冲器下相同的输出响应.

互联网摘选

This paper presents a novel passive snubber circuIt'suitable for inverter bridge leg modules.

提出一种适用于逆变桥臂模块的吸收电路.

互联网摘选

To resolve this proplem. snubber circuit and soft switching technology are recommanded.

为了解决这个问题,常用的两种方法是使用缓冲电路及软开关技术.

互联网摘选

Relation between construction parameter of snubber on truck Type 8A and the enhancement of its life

转8A型转向架减振装置结构参数与提高其寿命的关系

互联网摘选

Thyristors and snubber components have been operating well for three years.

经三年的现场使用,保护元件及功率器件均工作安全可靠,证实了本方法的可行性.

互联网摘选

Study on Passive Snubber Circuit with Energy Recovery for Power MOSFET

功率MOSFET馈能式缓冲电路的研究

互联网摘选

The Three-level CUK Circuit with Passive Lossless Snubber

无源无损软开关三电平CUK电路

互联网摘选

The voltage overshoot across the power electronics and the voltage variation could be suppressed by snubber.

功率器件的电压过冲和电压变化率可以通过缓冲电路来进行抑制.

网络文摘精选

A design method of thyristor snubber circuit with PSPICE simulation software is presented.

介绍了一种用PSPICE仿真软件设计晶闸管吸收电路的方法.

互联网摘选

The use of the snubber CIRCUIT is usually recommended for unity gain configurations.

单位增益配置时通常推荐使用缓冲器电路。

互联网摘选

The mechanical snubber device on the machine may prevent damage to parts caused by overload.

机上的机械缓冲装置可避免过载而引起的几件损坏.

互联网摘选

A study of transient state on triac off-state voltage and optimization of parameters of snubber circuit for 3-phase induction motors switching application

基于交流电机负载双向晶闸管关断电压暂态研究及缓冲电路参数优化

互联网摘选

Having much less turn-off time, eliminating the current over-shot and improving the turn-off consistency, the proposed snubber is suitable as the load energy snubber of TEM transmitter.

实验证明，推荐电路具有关断延时短、正负脉冲一致性好、无过冲现象等特点，适宜于TEM发射机的负载能量吸收电路。

互联网摘选

An engineering oriented method of snubber components optimization in three-phase full-bridge rectifier is given.

以三相桥式全控整流为例,给出了寻求保护元件参数最优解的工程化方法.

互联网摘选

Mathematical analysis, Pspice simulation and experimental results snubber scheme.

电路解析分析 、 仿真波形及实验结果也同文给出.

互联网摘选