tip angle的例句大全

The bladder neck position was plotted on an assumed X Y coordinate system with the tip of symphysis pubis as origin and symphyseal mid line intersected the X and Y axis at an angle of 45 °.

以耻骨联合下端为原点，沿耻骨联合线45°夹角分别建立XY坐标轴。

互联网摘选

The projection line of lig teres hepatis was located along the line of 30.9 ° angle right to the abdominal linea alba and passing through the crossed point of umbilicus and abdominal linea alba, called tip point.

其体表投影大致位于：以腹白线与脐之交点为顶点，过顶点在腹白线的右侧，作与腹白线成30.9°夹角的边线上。

互联网摘选

Measured from the lip up, the optimum angle of rotation at the nasal tip-the amount the nose is turned up-should be 106 degrees to enhance a woman's looks, says new research.

新研究声称，从上唇开始，鼻尖的最佳倾斜度——也就是鼻子的翘度，应该是106度，这样的鼻子最能增加女性魅力。

互联网摘选

Welding parameters such as angle of bending tip, pulse voltage, wire feed rate, pulse mode, size of groove and welding speed can affect the appearance of weld.

导电嘴弯曲角度、送丝速度、峰值电压、协同模式、焊接速度和坡口尺寸均会对窄间隙焊缝成形产生重要影响。

互联网摘选

Accordingly, Stress Triaxiality, Strain Energy Density Factor and Maximum Circle Tensile Stress near the crack tip and their variation due to the circle angle variation can be derived.

根据内部裂尖附近的位移分量和应力分量可以得到裂尖的应力三维度，应变能密度因子以及裂尖附近的最大周向拉应力随着圆周角的变化而变化的情况。

互联网摘选

Through comparison with three dimension single notch compact tension specimen, effect of inclined crack plane and different angle loading to SIF and SERR of crack tip is analyzed and summarized.

通过与三维单边直裂纹的紧凑拉伸试样进行比较，分析并总结倾斜裂纹面及复合加载对裂纹尖端应力强度因子和能量释放率的影响。

互联网摘选

Designing of external gear shaper cutter with large tip relief angle can improve the meshing quality.

滚刀、插齿刀设计成较大的修缘角，有利于提高啮合质量。

互联网摘选

The method for determining the open angle in crack tip is promising.

确定裂纹尖端张开角是一种有发展前途的方法；

互联网摘选

To provide a theoretical basis for the conical stylus cone angle selection. ( 2) Analysis of the stylus tip radius and the stylus static pressure causing timber roughness parameter measurement error, calculation of the roughness measurement error value caused by the different tip radius.

分析触针针尖圆角半径和触针静压力引起的木材粗糙度测量误差，计算不同针尖半径造成的粗糙度测量误差值。

互联网摘选

Spotsi-the angle at the tip of the cone, or the spot aperture.

圆锥体顶角角度，或是聚光灯孔径。

provided by jukuu

The new flash boiling spray model predicts spray tip penetration and spray cone angle and its development trend, in good agreement with the experimental results.

模拟结果表明，闪急沸腾喷雾新模型较好的预测了喷雾贯穿距及喷雾锥角及其发展趋势，喷雾图像与实验结果吻合较好。

互联网摘选

To slice, tip the cutting knife up on an angle, to use the far end ( away from you) of the blade.

对于切片而言，先把刀的一端抬起，成三角形，然后用离你较远的那一段的刀刃来切菜。

互联网摘选

The final tip diameter of the fiber probe obtained from experiment was between 40~ 80nm, which was satisfied with the requirements of nondestructive measurement. And the angle of taper was at around 30 °, which might ensure the efficiency of light transmission.

实验得到的光纤探针尖端直径在40～80nm之间，符合细胞内无损测量要求，探针锥形角度大约在30°，很好地保证了光的传输效率。

互联网摘选

The Effects of Tip End Ejection Area Ratio and Installation Angle on Heat Transfer of Orthogonally Rotating Rectangular Duct with Staggered Pin Fins

正交旋转径向出流带扰流柱的矩形通道出口节流及安装角对传热的影响

互联网摘选