surface element的例句大全

For certain nonanalytic curved surfaces, we studied further modeling method and rendering method based on surface element.

针对某些非解析曲面，研究了基于表面元素的造型方法和绘制方法。

互联网摘选

Technique based on surface element of prepositive disposal in predicting RCS of aircraft

飞行器RCS预估计算前置处理的曲面元方法

互联网摘选

Through finite element numerical calculation and experiment test on pressure vessel containing inner portrait surface crack, the results show that;

通过对一台含内壁纵向表面裂纹的实物压力容器的有限元数值计算和实验测试，结果显示：初始椭圆形表面裂纹在疲劳扩展过程中形状逐渐趋圆并保持圆形继续扩展。

互联网摘选

The convergence of tetrahedral isoparametric element is analysed in this paper, and the optimal H~ 1 error estimate is obtained, then it is used to solve 3-dimensional 2-order homogeneous Dirichlet problem on surface domain.

本文的主要内容是讨论了四面体等参元，分析了其收敛性并给出了最优H~1误差估计，并把它应用到曲面区域的三维2阶齐次Dirichlet问题。

互联网摘选

Utilizing molecular dynamics and finite element coupling method, a two dimensional adhesive sliding contact problem between a rigid cylinder and textured surface is investigated.

采用分子动力学与有限元耦合的多尺度方法，求解二维刚性圆柱表面压头与弹性纹理表面的纳观粘着滑动接触问题。

互联网摘选

Coupled Temperature-displacement Finite Element Analysis of a Slider Sliding Contact with a Textured Disk Surface and the Critical Condition for Demagnetization

表面纹理磁盘滑动接触的温度和应力及退磁临界条件的研究

互联网摘选

By energy transition principle of elastic mechanics, the physics relation between strain around fault and tectonic force on fault surface is set up and main body element model of crust strain is put forward.

利用SCHOLZ断层能量动态平衡过程，建立了断层周边应变累积与断层面构造力的一般物理关系，据此提出以断裂带为主体的地壳应变主体单元模型。

互联网摘选

Engineering Solution and Finite Element Solution of Crack Tip Opening Displacement for Surface Plate with Center Through Crack

中心裂纹板张开位移研究

互联网摘选

Using the finite element method, to analyze the surface layer of asphalt added gravel base case temperature shrinkage cracking.

运用有限元基层裂缝模型分析了有沥青面层时基层温缩开裂情况。

互联网摘选

Below figure shows the relation between fumace temperatures, element temperature and element surface load under the condition that the element radiation isn't obstructed.

下图示出了元件辐射在不受阻碍情况下的炉温、件温度与表面负荷之间的关系。

互联网摘选

By means of in-situ tensile test of the specimen of bi-morphic alloys of γ-TiAl, observation upon its corresponding fracture surface with scanning electron microscope, and finite element computation, the tensile fracture mechanism of these alloys is investigated.

通过对双态组织的扫描电镜原位拉伸实验、相应的断裂表面观察以及有限元计算，研究了TiAl基合金双态组织拉伸的断裂机理。

互联网摘选

ALE finite element method for free surface Navier-Stokes flow using fractional step methods

带自由液面Navier-Stokes流动问题的ALE分步有限元方法

互联网摘选

Combining Monte Carlo simulation with finite element method, this paper gives a way to analyze the probability of the deformation stability of foundation pit. Response surface method is employed to improve the calculation efficiency of direct Monte Carlo simulation technique.

将Monte Carlo模拟法与有限元技术结合，对基坑变形的稳定性进行可靠度分析，并通过重构响应面来提高Monte Carlo模拟法的计算效率。

互联网摘选

In this survey, the surface γ dosage, radioactivity specific activity, uranium and thorium series equilibrium, the content of radioactive element of three kinds of typical Chinese zircon mineral has been analyzed, and the component and radioactivity of zircon in Wanning, Hainan Province tested.

调查分析了我国3个典型矿区锆英砂堆放表面γ剂量、放射性比活度、铀系和钍系平衡状况以及放射性元素含量；测定了我国海南万宁矿区锆英砂的组成及放射性。

互联网摘选

In this paper, two types of isoparametric finite element are used to predict surface pressure distribution on the three dimensional wing which are placed in the subcritical steady flow by the variational FEM.

本文使用了两种类型等参元，通过变分法，计算了三维机翼亚临界定常位势流中的压力分布，计算结果与试验结果符合较好。

互联网摘选

By use of V notched round bars with different theoretical stress concentration factors as finite element models ( FEM) of tensile screw threads, stress intensity factors ( SIF) of surface cracks of screw threads are calculated.

将拉伸螺杆简化为理论应力集中系数Kt不同的带V形缺口圆杆，采用裂纹尖端为20节点奇异单元的三维有限元模型，对螺杆半椭圆表面裂纹的应力强度因子进行了计算。

互联网摘选

A static analysis of the No. 2 leg-cone of a tricone bit is conducted by the finite element method, and the distribution pattern of the contact stress on the leg journal and thrust surface with different bearing clearances is worked out.

用有限元法对某型三牙轮钻头的2号牙轮－牙爪进行了静力计算，求得不同轴承间隙时牙爪轴颈及止推面上的接触应力分布规律。

互联网摘选

On the Design and Calculation of Ball Surface Hydrostatic Bearings Finite Element Method for Radial Deformations of Tilting Pad Journal Bearings

液体球面静压轴承设计计算研究径向可倾瓦轴承表面法向变形的有限元分析

互联网摘选

The Finite Element Analysis of Surface Deformation of A Station in No.5 Route of Beijing Metro

北京地铁五号线某车站地表变形的有限元分析

互联网摘选

FEA on Surface Shot Peening to Strengthen Railway Vehicle Bodywork; tetrahedral element characteristic

车体钢结构表面喷丸强化有限元分析四面体单元体的特征

互联网摘选