high temperature curing的例句大全

High temperature curing of unformed plate in valve-regulated lead-acid battery

阀控铅酸蓄电池生极板的高温固化

互联网摘选

Phenolic aldehyde epoxy resin exhibits high radiation reactivity, and its high temperature modulus and glass transition temperature ( Tg) after curing is higher than that of bisphenol A epoxy resin.

酚醛型环氧树脂辐射反应活性高，固化后的高温模量及玻璃化转变温度高于双酚A型环氧树脂，但固化度沿辐射深度方向下降较快。

互联网摘选

It can be quicky cured and resisted high temperature for class H in a short curing time and low evaporation losses.

它耐高温达到H级，固化速度快，贮存周期长，挥发率低。

互联网摘选

This resin is characterized by high strength, good toughness, acid and alkali resistant, moisture-proof, and brittle resistant at low temperature after curing.

环氧化聚丁二烯树脂具有强度高、韧性好，耐酸碱、防潮湿、固化后低温不脆等特点。

互联网摘选

the development of the compressive strength of fly ash based mineral polymer at different curing temperature as well as at normal temperature after curing in high temperature for one day were studied.

研究了不同养护温度下粉煤灰基矿物聚合物的抗压强度，以及经过1d高温养护后常温条件下强度的发展特点。

互联网摘选

study on resisting high temperature ba-phenolic resin adhesive curing at room-temperature

常温固化耐高温酚醛树脂胶粘剂的研制

互联网摘选

For traditional thermal curing powder coatings, there has a big limit of high curing temperature.

但普通的粉末涂料存在固化温度偏高,不能用于热敏性底材,限制了其应用范围.

互联网摘选

It's curing temperature high and difficult to molding.

聚酰亚胺固化温度太高,并且难于成型加工.

互联网摘选

High Temperature Rapid Curing One-Component Epoxy Adhesive and its Application

高温快速固化单组份环氧胶粘剂及其应用

互联网摘选

However, the high benzoxazine resin curing temperature, low cross-linking density of the cured product, brittle and other defects restrict its application in some special fields.

但是，苯并恶嗪树脂固化温度偏高、固化产物交联密度偏低、性脆等缺陷制约了其在一些特殊领域的应用。

互联网摘选

Low temperature and high vacuum tumble technology being widely used at home and abroad can shorten the curing time and improve product textural properties.

低温真空滚揉能缩短腌制时间，改善产品质构，目前国内外广泛采用；

互联网摘选

Experiment indicated that TPX mould was an ideal plastic mould for casting of epoxy resin which was suitably curing at high or middle temperature.

实验表明它是一种适用于高、中温固化环氧树脂浇铸成型的理想的塑料模具。

互联网摘选