heat load的例句大全

From experimental readings, the dynamic changing regularity of water wall parameters and the response curve are confirmed under the disturbance of outlet pressure, heat load, inlet mass flow speed and inlet temperature. Sone theoretical analyses are given.

在出口压力、热负荷、进口质量流速和进口温度参数扰动下，确定水冷壁参数动态变化规律和响应曲线，并进行了理论分析。

互联网摘选

Puffing gas can reduce the plasma temperature in the scrape off layer ( SOL). Injected impurity can increase the radiation power in SOL. Both of them make the heat load on the plate target smaller.

喷气能降低删削层（SOL）处等离子体温度，注入的杂质增加了SOL处的辐射功率，使靶板的负载降低。

互联网摘选

Discussion on Heat Load of Paint Drying Box for LPG-bottle Production Line Structure of Stove for Baking Paint

钢瓶热载体烤漆炉热负荷计算论漆膜烘干炉的结构

互联网摘选

The safe temperature for cast iron stave was 1280 ℃. In addition, the safe heat load was 39.6kW/m2.

铸铁冷却壁安全工作温度为1280℃，能够承受的安全热负荷为39.6kW/m2。

互联网摘选

The manual reaming is easy to cause problems, such as over norm of heat load and CO volume fraction. The reform of gas range should be conducted by specialized manufacturers.

手工扩孔易造成热负荷及CO体积分数超标等问题，灶具改造应由专业厂家进行。

互联网摘选

The Chinese cooking appliance is made and designed according to Chinese cooking ways. Its main features including high heat load, high heat intensity of loading vessel bottom. However, its efficiency is not pretty high, and it generates a lot of smokes and toxic gases.

中餐灶是根据中餐的烹饪习惯和方式设计制造的，其主要特点是热负荷较大，锅底热强度大，但热效率不高，而且产生大量的油烟以及有害气体。

互联网摘选

Heat Load Evaluation of Various Extended Bladder Coverage Anti G Suit

不同扩大囊覆盖面积抗荷服的热负荷评价

互联网摘选

Discussion on Heat Load of Paint Drying Box for LPG-bottle Production Line Structure of Stove for Baking Paint

钢瓶热载体烤漆炉热负荷计算论漆膜烘干炉的结构

互联网摘选

The application effects show this technology is simple and safe, the heat load of the cooling stave can reduce by 8%~ 10%.

应用效果表明：该技术简单易行，操作方便，安全可靠，冷却壁热负荷可减少8%～10%。

互联网摘选

A major challenge scramjet engines currently faced is the high aerodynamic heat load. The wall temperature of combustion chamber without cooling can reach 3000K, which exceeds the limit of the general material used.

超燃冲压发动机目前面临的一大难题就是极高的气动力热载荷，燃烧室壁面温度在未经冷却的情况下能达到3000K。这超过了一般结构材料的使用极限。

互联网摘选

Utilizing heat sink is effective to reduce the thermometer heat load due to the thermal conductor of the leads, and to increase the accuracy of the temperature measurement.

运用热沉能够有效地减小由引线导热引起的温度计的热负荷，提高温度测量的精确度。

互联网摘选

The results showed that, when the evaporation temperature increase, the heat load, the material evaporation and condensation capacity, the system heating coefficient of performance COP, compressor theoretical power consumption and the theoretical heating medium flow rate all increased.

实验结果表明，系统热负荷、物料蒸发量和冷凝量、系统制热系数COP、压缩机理论耗功量和理论热媒流量均随着料液蒸发温度的升高而增大。

互联网摘选

Taking the minimum control energy reentry trajectory with fixed terminal time and the minimum total heat load reentry trajectory as examples, some key problems such as parameterized method were discussed in detail.

以终端时间固定的空间最小控制能量再入轨迹和终端时间自由的平面最小热载再入轨迹为例，详细讨论了遗传算法用于再入轨迹优化设计所需要解决的一些关键问题。

互联网摘选

Comparison and Analysis in Heat Load Calculating Method of Cold-Storage Between China and Japan

中日冷库热负荷计算的比较分析

互联网摘选

Temperature Simulation and Testing for the Layered Tube Wall in Heat Load

层合管结构受热载荷的管壁温度模拟及测试方法

互联网摘选

The regulation of the fan depends on the ambient air temperature and the heat load of the condenser.

轴流风机运行方式的调整，依赖于环境温度和机组热负荷的变化。

互联网摘选

The factors, as heat load, axial tilt angle, lateral tilt angle and heating area, on the FHP performance have been studied. The thermal conductivity ratio and its combination parameter with the density of different FHPs have been compared.

研究了加热功率、轴向倾角、侧向倾角和加热面积等因素对热管传热性能的影响，比较了不同实验件的导热系数和其与密度的组合参数。

互联网摘选

Calculation of Heat Load and Drawing of Temperature Curve of the Heating System

供暖系统热负荷计算及供回水温度曲线的产生

互联网摘选

The heat load to the vacuum vessel thermal shield ( VVTS) is analyzed by FLUENT finite element software in order to demonstrate that the design of cooling tubes is reliable.

采取有限元法对内冷屏的受热状况进行了计算分析，以验证内冷屏氦冷却管道设计方案的可靠性。

互联网摘选

Analyses the simulative fault of heat load increasing in an air conditioned room and obtains relatively perfect fault prediction results.

利用小波变换，对空调房间热负荷增大这一模拟故障进行了分析，得到了较理想的故障先兆预处理结果。

互联网摘选