back tooth的例句大全

Since a back tooth is bad, it became swollen.

后牙齿坏了，肿了起来。

互联网摘选

What? The government pays for stuff like this, and I can't get my back tooth fixed?

什么，政府花钱补助这种玩意儿，而我连补大牙的钱都没？

互联网摘选

This paper uses the Finite difference method to study the responding temperature value of the tooth back when the tooth is quenched by laser and gives the relation charts of temperature value with laser parameters and gear parameters.

针对齿轮激光表面淬火背面回火现象，采用有限差分法分析研究了背面温度响应值，并给出了温度响应值与激光工艺参数、齿轮参数的关系线图。

互联网摘选

Make sure you brush the top, front and back surfaces of each tooth. Don't forget your back molars.

确保刷到每一颗牙齿的顶部和前后表面。不要忘记磨牙。

互联网摘选

no tooth on the maxilla and the back of the dentary.

齿骨后端和上颌骨没有牙齿。

互联网摘选

many famous scenic spots such as tooth dragon bay, great east sea, end of the earth and deer looking back, attract thousands of visitors every day.

牙龙湾、大东海、天涯海角、鹿回头等著名景点，每天都吸引众多的国内外游人。

互联网摘选

Move the tooth brush back and forth with short, vibrating stokes.

用短距离, 振动的力量前后移动牙刷.

网络文摘精选

I could feel him combing , straight back, first the big comb, then fine-tooth one.

我可以感觉得到,他在直接往后为我梳理, 开始用那把大梳子, 后来用细齿的那把.

互联网摘选

If you're going shopping, please bring back a tube of tooth-paste.

要是你上街买东西, 请带一支牙膏回来.

互联网摘选

It is distinct from profile of every axial section of tooth back of relief grinded hob.

铲磨滚刀齿背的各轴截面截形都不一样。

互联网摘选

the result shows the seal element can hold back the leakage through axial clearance and reduce friction power loss between scroll tooth and bottom of scrolls.

结果表明：密封条不但可以阻止通过轴向间隙的泄漏，而且降低了涡旋齿与涡盘底部摩擦功率损失。

互联网摘选

'No thank you,' said the Manager, standing, perhaps from the force of winter habit, with his back against the chimney-piece, and looking down upon the Captain with an eye in every tooth and gum.

不，谢谢您，经理说道；也许是由于冬天养成的习惯，他还继续站着；他的背靠着壁炉架，并往下望着船长，好像他每个牙齿和牙床中都长着一只眼睛似的。

互联网摘选

When designing gear hob, worm gear hob and shaping milling cutter, it should be verified whether the interfere would occur between grinding wheel and the next gear tooth on condition of pledging the relief grinding length of the back of tooth.

在设计齿轮滚刀、蜗轮滚刀和成形铣刀时，要校验在保证齿背铲磨长度的情况下，所用砂轮是否和下一个齿发生干涉。

互联网摘选