analog error的例句大全

Optimization of Hardware Overhead in Continuous Checksum-Based Analog Error Detection Circuit

基于连续校验和的模拟检错电路硬件开销的优化

互联网摘选

The analog Phase Locked Loop has high sensitivity and low measurement error, so it is widely used in the receiver of such equipment as interferometer, continuous-wave radar, telemetering device, etc. However, it has the problem of track stability.

模拟锁相环灵敏度高、测量误差小，因而大量地应用于干涉仪、连续波雷达、遥测等设备接收机中，但其存在环路跟踪稳定性的问题。

互联网摘选

This paper discusses the traditional analog integrator, and introduces a new integrator based on real-time drift compensation schemes. This new design can significantly reduce the integral error caused by input offset 、 temperature-induced drift 、 noise and so on.

讨论了单运放模拟积分器的特点，提出了利用实时积分漂移补偿的方法设计新型积分器，解决了积分过程中积分器本身的等效输入偏移量、温度漂移及地噪声等带来的积分误差。

互联网摘选

There are some disadvantages in conventional analog synchronizer such as fixed error threshold and fixed step size.

传统的模拟型同步环具有误差门限和步长固定的缺点。

互联网摘选

This paper introduces a kind of nonlinear-carrier ( NLC) controller for high power factor boost converters. Using the NLC controller, input line voltage and current sensing, error amplifier in the current shaping loop, and analog multiplier/ divider are eliminated.

阐述了一种非线性载波（Nonlinear-carrier）控制的PFC电路，该电路与传统单级功率因数校正电路相比不再需要输入电压、电流采样以及复杂的模拟乘法器和电流误差放大器电路。

互联网摘选

Application of the m Sequence In the Bit Error Test of the Trunked Radio Receiver analog-digital automatic program tester

m序列在数字集群接收机误码率测试中的应用模数自动程序测试程序

互联网摘选

Computer Analog Analysis of the Trace Length Error in Joint Surveys

节理测量中迹长误差的计算机模拟分析

互联网摘选

At present, the reading of analog display instruments is usually completed by the artificial reading, however this method is influenced by the human subjective factor, so the reading error of the data is very big, and the reliability is low.

目前，这些指针式仪表的读数通常是由人工判读来完成，然而这种方法受人主观因素的影响，会导致判读的数据误差较大，可靠性不高。

互联网摘选

The principle of the analog-digital composite compensation technique is described and the factors causing fitting errors arc analyzed. The formula for calculating the maximum error is derived.

还叙述了模-数混合补偿技术的工作原理，分析了引起拟合误差的因素并推导出计算最大误差的公式。

互联网摘选

In indirect tension control, the calculating of roll diameter 、 dpomic and statics compensation current of tension is complex. By using analog multiplier and divider, there will be large error and drift and therefore it difficult to implement accurate tension control.

间接张力控制系统中，卷径D、动静态张力补偿电流计算复杂，用模拟乘除器实现起来误差大、漂移严重，很难实现精确的张力控制。

互联网摘选

Analog interpolation method and its measurement error analysis

模拟内插法及其测量误差分析

互联网摘选

Investigation on Measuring Error Using an Analog Probe

使用比例式探测器的测量误差的研究

互联网摘选

an improvement in differential non-linearity of analog-digital conversion dwt error derived from the nonlinearity of adc is discussed.

主要讨论了模数转换器（ADC）非线性对DWT带来的误差。

互联网摘选

We analyzed FFT spectrum of ideal analog data with quantity error, theoretical data with nonlinear error and error from limit slew rate of amplifier. We also analyzed FFT spectrum of data with combined errors.

介绍了理论模拟数据的FFT频谱分析，分别研究了量化误差、由放大通路的有限压摆率所引起的误差和非线性误差对信号频谱的影响以及它们之间的相互叠加后的频谱。

互联网摘选

After calculating the analog to digital convert error, each stage processes the next stage input signal immediately, and this increases the value of output signal flow speed.

每一级电路计算完它的模拟转换误差后，马上就可以对下一个输入数据进行计算，提高了随机数产生速度。

互联网摘选

In the virtual test environment, it analyzed and simulated the measurement error of the analog system, obtained the capture rate of the specific target surface size and the specific target parameters in simulation system.

在虚拟试验环境下，对模拟系统的捕获率、测量误差进行了分析与仿真计算，获得了在特定靶面大小、特定目标参数下的模拟系统的捕获率。

互联网摘选

Chapter 4 describes the theory of interpolating circuit that uses analog circuit to turn error pulses to voltage. The design of interpolating circuit and devices selection is introduced in this section too.

第四章阐述了利用模拟电路将误差脉冲转化为电压量的内插电路原理，论述了电路的设计及器件参数的选择。

互联网摘选