Researchers found that women are overcome by a burning desire to share gossip as soon as they hear it.

A burning desire for sth. He has a hunger for/ after knowledge.

对某事物的强烈的欲望他有强烈的求知欲。

互联网摘选

There is a burning desire to right the wrongs I have committed.

此刻有种强烈的欲望去弥补曾经犯下的过错。

互联网摘选

You see, true learning takes energy, passion, a burning desire.

真正的学习需要精力、激情和热切的愿望。

互联网摘选

First and most important, its necessary to have a burning desire to remember, its difficult to recall anything without wanting to do so.

首先，并且最重要的是必须有记忆的强烈欲望。毫无记忆热忱却要将东西记住谈何容易。

互联网摘选

The article compares the performance of the antisepsis layer which used very often, such as PVC adhesive tape, epoxy power, coal tar bitumen, etc.

常用的防腐层有聚乙烯胶带、环氧粉末、煤焦油沥青等，文章对这些防腐层的性能进行了比较。

互联网摘选

The Uncertainty of the Measurement Results of the Withstanding Voltage Testers ( Alternating Voltage) Test method for dielectric strength of insulating adhesive tape at power frequency

耐电压测试仪（交流电压）示值误差的测量结果不确定度评定GB/T14517-1993绝缘胶粘带工频耐电压试验方法

互联网摘选

Construction could be improved heat sealant viscosity on the sub base material, and therefore the majority of base material was sticky adhesive has good power.

热施工可改进密封胶对被粘基料的湿润能力，因此对大多数被粘基料具有良好的粘接力。

互联网摘选

Study on the New Type of High Thermal Conducting Adhesive Used in Power Electronics Package

新型电力电子器件封装用导热胶粘剂的研究

互联网摘选

Test method for electric strength of insulating adhesive tape at power frequency

GB/T7752-1987绝缘胶粘带工频击穿强度试验方法

互联网摘选

This observation led to the presumption of a struc-tural model of the electrode and explained the beneficial effects of the intermediate layer on depressing the interfacial resistance of the electrode and improving the adhesive power between both β-PbO_2/ SnO_2 and Ti/ SnO_2.

因而提出了电极结构模型的假设，并且解释了中间层对降低界面电阻，改进β&PbO2/SnO2与Ti/SnO2之间结合强度的有益作用。

互联网摘选

S: The use of MQ silicone resin as reinforcing material for additive type liquid silicone rubber ( LTV) could endow the LTV with better mechanical properties and fluidity. It has better adhesive power for metals, glasses and ceramics.

MQ树脂用作加成型液体硅橡胶（LTV）的补强材料，可赋予LTV较好的机械性能、很好的流动性，对玻璃、陶瓷等材料较好的粘接性；

互联网摘选

The 3rd-generation MSCs were cultured combining with PLGA-ASP-PEG in vitro, while cells cultured in PLGA as control group. The cell adhesion rate and the adhesive power were examined by conventional precipitation method and micropipette aspiration technique respectively.

将第3代MSCs以1.0×106/ml接种到PLGA-ASP-PEG材料上，测定细胞黏附力和黏附率；

互联网摘选

The glue has some technical characteristic such as great elongation, high elasticity, strong adhesive power with concrete, adjustable color, fitting surface-drying time, tolerably working on the condition of moist slot, and so on.

该嵌缝材料具有伸长率大、弹性高、与混凝土粘接力强、色彩可调、表干时间适宜，并可在缝内潮湿情况下施工等技术特点。

互联网摘选

After annealing at 50~ 350 ℃, the adhesive power of aluminum film on pure Cu substrate is higher than that before annealing, and increases with the increase of annealing temperature. Within the layer the copper?

在50~350℃之间退火后，铝膜对纯铜基体的附着力高于退火前，且随退火温度的升高而增大。

互联网摘选

The performances of three kinds of gels were compared by the experiments of viscosity, gel intensity, syneresis rate, adhesive power, gel freezing point as well as melting point and so on.

进行黏度、凝胶强度、凝胶水析率、凝胶黏着力、凝胶凝固点及熔点测定等试验，以对比几种凝胶的性能。

互联网摘选

Aluminum film is produced on glass, H13 steel, plastic and pure Cu substrate by resistance heating vacuum evaporation, and the adhesive power of aluminum film is determined and analyzed.

采用电阻加热式真空蒸镀法在玻璃、H13钢、塑料和纯铜基体上镀制铝膜，并对其附着力进行了测试和分析。

互联网摘选

Traditional methods of producing catalyst coating have disadvantages of complex technology and higher cost, and the coating granules are easily broken off owing to weak adhesive power and then block the reactive channel.

传统的催化剂涂层制备方法工艺复杂、成本较高，存在涂层附着力不强、容易脱落及堵塞通道等问题。

互联网摘选

Conclusion EDTA with density 10% is more effective in both the rinse of smear layer of root canal and the enhancement of adhesive power of casting post.

结论浓度为10%的EDTA在去除根管内玷污层，提高桩冠固位力方面效果最好。

互联网摘选

Adhesive power, peeling strength, chromatic aberration, impact strength retention rate and other indicators can be more comprehensive characterization of color profiles of weathering resistance.

附着力、剥离强度、色差、冲击强度保留率等指标能比较全面的表征彩色型材的耐候性能。

互联网摘选

This paper dealt with the methods for increasing the properties of glass fiber reinforced PP ( GFRPP) and the adhesive power of glass fiber and PP.

探讨了提高玻纤增强聚丙烯性能、提高玻纤与聚丙烯结合力的方法。

互联网摘选