Selecting a university for the 40 students were tested for The Improve Verbal-Image Cognitive Style, test-retest reliability of the test, it is 0.967, this value is higher than the domestic and international letter to other CSA test value.

From the analysis of the temporary item bank, it is found that the generating item has more suitable psychological psychometric attributes and the test-retest reliability of M-AIG system reaches 0.83 ( p0.01).

对临时项目库的分析发现生成的项目具有较合适的心理计量属性，M-AIG系统的重测信度达到0.83（P＜0.01）。

互联网摘选

In addition, the study examines the reliability of internal consistency and test-retest reliability in every dimension on the three sub-scales. The results reach an acceptable level, which show that the tool is reliable.

另外研究还考察了测量工具的内部一致性信度和重测信度，均达到了可接受水平。

互联网摘选

The consistency reliability and the split-half reliability range from 0.56~ 0.84 and 0.54~ 0.83. Two-week test-retest reliability was 0.86. Expert assessing showed a good content validity.

各分量表的内部一致性信度系数和分半信度系数分别为0.56-0.84和0.54-0.83；两周重测信度系数0.86。

互联网摘选

The reliability analysis included the mean inter-item correlation, Cronbach's a coefficient, split-half reliability, test-retest reliability and the generalizability analysis.

选用项目间平均相关系数、Cronbach'sα系数、分半相关系数和重测相关系数以及概化系数检验量表的信度；效度检验主要包括内容效度、结构效度和实证效度。

互联网摘选

Internal concordance coefficient ( Cronbach a coefficient) split-half coefficient, and test-retest reliability were analyzed to verify the reliability of the questionnaire.

修订的《工作倾向问卷》具有较好的信度和效度。本研究采用内部一致性系数（Cronbachα系数）、分半信度和重测信度检验问卷的信度。

互联网摘选

A test-piece is shaped into a beam of about 20 cm length and its upper surface is highly polished. The test-piece is bent convex upwards; on that occasion one had better plan the maximum bending stress to be about 20 bar or less.

试件加工成20cm长的梁，并高度磨光其上表面，把它弯成向上凸，其最大弯曲应力宜为20bar或稍小一些。

互联网摘选

Under the full consideration on the interaction of the temperature field, the microstructure field and the internal stress field of a quenching test-piece, the numerical calculation models of the three kinds of fields of a shaft-type test-piece are set up.

在充分考虑淬火试件温度场、显微组织场和内应力场相互作用的情况下，建立了轴类淬火试件三种场量的数值计算模型。

互联网摘选

This paper analyse the main factor which affect the testing outcome of test-piece intensity of HSC, and the coherency between test-piece intensity and concrete member intensity, pose the issue and step of the testing of concrete member intensity.

分析了影响高强混凝土试件强度检测结果的主要因素，以及试件强度与构件混凝土强度的相关性，提出了构件混凝土强度检验中存在的问题和措施。

互联网摘选

The paper introduces the synthesis and properties of the adhesive, discusses that shear strength can be affected by the thickness of adhesive layer and drying time of the test-piece which has been immersed in water for 24 hours.

介绍了它的合成方法和性能，讨论了粘接试件浸水24小时后的不同自然干燥时间、胶层厚度等对剪切强度的影响。

互联网摘选

This thesis studies particularly the medium flow field in a quenching tank and its relationship with the temperature field, the microstructure field and the internal stress field of a shaft-type test-piece, by using computer simulation and experiment examination.

针对上述问题本文用计算机模拟与试验研究相结合的方法，着重研究了淬火槽中介质的流场以及介质流场与轴类试件的温度场、显微组织场和内应力场的关系。

互联网摘选

Figure 3.1 shows a typical test piece, and it will be seen that a section is of reduced diameter, so that the extension and the breakage will occur along that part of the test-piece.

图3.1表示典型的试样，可以看到有一段直径减少，以便使延伸和破裂沿着试样的那部分发生。

互联网摘选

A bending of the test-piece should be reduced to a difference between the profile at the measurement and the initial profile which was determined before bending.

试件的挠度应减小到观测时的轮廓与弯曲前已确定了的初始轮廓之间的差值。

互联网摘选

The effect of preheating, test-piece thickness and coupling agents on the electric properties and the mechanical properties of the materials have been specially studied.

试验结果表明，模压前合理的预热可以显著地提高酚醛塑料的电性能及力学性能；

互联网摘选

A bend test is a simple test fOR ductility that does not require special equipment, OR a specially shaped test-piece.

弯曲试验是测试韧性的简单试验，不要求特别的测试设备，或规定形状的试样。

互联网摘选

Effect of Test-piece Thickness on Laser-Hardened Zone

试件厚度对激光淬硬层的影响

互联网摘选

There is a fixed relationship between the gauge length and the cross-sectional area of the test-piece at the reduced diameter.

定向低频分析与测距浮标标距长度和试样在直径减少处的横截面面积之间有固定的关系。

互联网摘选

The tensile strength. This is defined as the maximum force taken by the test-piece, divided by the original area.

抗拉强度这可以定义为试样承受的最大力除以原始面积的所得的结果。

互联网摘选

Thus continuing the regular measurements of the bending curves of the test-piece, one could construct a creep curve.

如此继续进行试件的挠度观测，就可绘制出蠕变曲线。

互联网摘选

Booz& company, another consultancy, points out that big companies often test-market new products on Nordic consumers because of their willingness to try new things.

另一间咨询公司博斯公司也指出一些大企业常常在北欧消费者身上对新产品进行市场测试，原因在于北欧人很乐意尝试新事物。

互联网摘选

The display apparatus for a test-chart, the memory device and the keyboard are respectively connected with the processor.

所述视力表显示装置、存储器、键盘分别与处理器相连。

互联网摘选