Using the interface technology between Pro/ E and ANSYS software, the simulation analysis of stress status of the assembly Line designed in Pro/ E under a certain load is made.

1、

The Q subscription specifies a manual ( E) load phase ( HAS LOAD PHASE keyword).

Q订阅指定手工装入阶段（HAS LOAD PHASE关键字）。

互联网摘选

2、

Want to accomplish get sth done once and for ever, build, or else do poorly done work over again is newer, must hold to quality first principle, cannot seek rate blindly, drive a measure.

要做到一劳永逸，一次修筑，再不返工更新，必须坚持质量第一的原则，不可盲目求速度、赶数量。

互联网摘选

3、

The failure of oil well tubing thread is one of the very important factors to cause the accident and to do poorly done work over again, so it must be inspected periodically.

油管螺纹部分的损伤是油田采油过程中造成事故、返工的一个重要原因，因此需要对其定期进行检测。

互联网摘选

4、

Standing under a huge glass roof, Woods was a sight that startle is stayed, wide open mouth never close, stick out from the steel teeth snapped under the ground, hit his toes did not feel.

站在巨大的玻璃屋顶下，呜兹被眼前的景象骇住了，大张着的嘴巴再也合不拢，木棒也从钢牙下啪嗒掉在地上，砸到了自己的脚趾都没有感觉。

互联网摘选

5、

The cause of influence on reinforced bar tooth length has been analyzed.

分析了影响螺纹钢牙筋长度的原因。

互联网摘选

6、

Length insufficience of reinforced bar tooth and settlement method

螺纹钢牙筋长度不足的原因及解决办法

互联网摘选

7、

Chip and Dale love to hear Clarice sing.

钢牙奇奇和大鼻帝帝喜欢听克拉瑞丝歌唱。

互联网摘选

8、

Study on A New O-ring

新型O型密封圈的研究

互联网摘选

9、

Work Design and O-ring Structure of Conveying Rubber Belts

输送带的环形结构及施工设计

互联网摘选

10、

An Analysis of O-ring Process Techniques Stabilization

橡胶O形圈工艺稳定性分析与计算

互联网摘选

11、

Sealing Performance Analysis of Rubber O-ring for Fluid Sealing

流体密封橡胶圈密封性能分析

互联网摘选

12、

Elastoplastic Contact Analysis of Metal O-ring Based on ANSYS

基于ANSYS的金属O形环弹塑性接触分析

互联网摘选

13、

Effect of Atomic Oxygen on Leakage Rate of O-Ring

原子氧对O型圈泄漏率的影响

互联网摘选

14、

Group Technology Viewed from the designing and manufacturing of O-ring extrusion dies

从O形圈压胶模的设计加工看成组技术

互联网摘选

15、

Check whether the right choice of the O-ring specifications.

校验是否选用正确规格的O形密封圈。

互联网摘选

16、

The Study of the Effect of O-Ring Exposure to Atomic Oxygen and Ultraviolet

原子氧及紫外线对O形圈泄漏率影响的研究

互联网摘选

17、

Finite Element Analysis of O-Ring with Single Side Gasket

加有单侧挡圈的O形密封圈有限元分析

互联网摘选

18、

Stress Analysis and Sealing Capability Research of Rubber Sealing O-Ring for Static Sealing

O形橡胶密封圈静密封应力分析及密封性能研究

互联网摘选

19、

Sealing Behaviour Research on Metal O-ring of Reactor Pressure Vessel

反应堆压力容器金属O形环密封性能研究

互联网摘选

20、

Research of Large Rubber O-ring in Special Pipe

大规格O形橡胶密封圈在特殊管道中的应用研究

互联网摘选