fuel injection pump

The measurement system in test bench of fuel injection pump have been introduced in this pape.

本文对喷油泵试验台量油系统进行了详细的介绍。

互联网摘选

Then the ECU has been installed on the fuel injection pump test bed and the elementary bench experiment is made.

最后，进行了电控单元的调试试验及喷油泵台架试验。

互联网摘选

Design and Development of Novel In-Line High Speed Light-Duty Fuel Injection Pump

新颖高速轻型直列式喷油泵的设计与研究

互联网摘选

The Latest Development of PM Fuel Injection Pump for Light-Duty Vehicles

发展中的轻型车用PM型直列式喷油泵

互联网摘选

The experimental investigation on matching four kinds of turbocharger and two types of fuel injection pump to a turbocharged diesel engine has been carried out.

本文用A、B、C、D四种涡轮增压器和X、Y两种喷油泵与480QZ型柴油机进行了匹配试验研究。

互联网摘选

The development of the complex measurer for the measurement of the fuel supply pressure of VE type fuel injection pump and the piston track of timing advance device

VE型喷油泵输油压力和提前器活塞行程综合测量仪的研制

互联网摘选

Experimental Study on Refitting Mechanical Governor of B-type Fuel Injection Pump into Electronic Governor for Series 135 Diesel Engines

135系列柴油机B型喷油泵机械调速器改装电子调速器试验研究

互联网摘选

The basic structure and operational principle of the test bench for fuel injection pump are described briefly and the basic design of fuzzy control system is analyzed.

简述了喷油泵试验台的基本结构和工作原理，分析了模糊控制系统的基本设计。

互联网摘选

Fault Diagnosis and Analysis of Torsional Vibration of Fuel Injection Pump Shaft

喷油泵轴系扭振的特征分析与诊断

互联网摘选

So, the electronic-controlled fuel injection pump test stand will become intelligent stand.

从而使电子控制喷油泵试验台改造成为智能型喷油泵试验台。

互联网摘选

Safe, dependable shutdown systems fit a range of engines and fuel injection pump governors.

安全, 可靠的关机系统适合各种发动机和喷油泵省长.

网络文摘精选

Governor , Turbocharger Fuel injection pump, Fuel injection repairing.

调速器,增压器,高压油泵, 油头修理.

网络文摘精选

Check coolant quantity, engine oil quantity in oil pan and fuel injection pump, check "three leakages" situations.

每天进行日常维护，检查冷却水量、油底壳及喷油泵内的机油量、检查“三漏”情况。

互联网摘选

the design, application and development of light-duty high-speed bq type fuel injection pump

轻型高速BQ型喷油泵的设计、应用和发展

互联网摘选

Study on Technical Parameter Measurement Method of Fuel Injection Pump Corrector

喷油泵校正器技术参数测试方法研究

互联网摘选

The engine must be the cylinder 1 up dead-centre when the fuel injection pump is being mounted on the engine for feeding fuel on time. The small end of timer pin must be fitted inner uf-ter the fuel injection pump mounted on the engine.

喷油泵总成向发动机上安装时发动机必须处于1缸上死点，以保证供油正时，喷油泵装上发动机后，正时销必须小端朝里装入。

互联网摘选

Investigation on Decelerating Fuel Injection Pump Cam Used in the Compound Combustion System of Diesel Engine

复合式燃烧系统采用降速油泵凸轮的试验研究

互联网摘选