MPa

It is measured at a speed of 2 m / s under load intensity of 1.96 Mpa.

它是在载荷集度为1.96Mpa和速度为2m/s时测得的.

词典精选例句

Tetrahydrofurfuryl alcohol ( THFA) was prepared from furfuryl alcohol with hydrogenation reduction by using the catalyst at 393-413 K, 0 25-0 4 h-1 and 2 0-4 0 MPa.

在393～413K、0.25～0.4h-1、2.0～4.0MPa条件下，用上述催化剂加氢还原糠醇制备四氢糠醇。

互联网摘选

With increase of the mass ratio of drug, tensile strength and break elongation of the membrane decreased from 28.4 MPa to 20.2 MPa and from 38.6% to 4.4% respectively.

随着膜中药物含量的增加，药物膜的拉伸强度，断裂伸长率均下降，分别从284MPa降至202MPa，386%降至44%。

互联网摘选

Effect of tempering temperature on the microstructure and mechanical properties of 600 MPa grade low carbon bainitic steel

回火温度对600MPa级低碳贝氏体钢组织和力学性能的影响

互联网摘选

Results: MPA has its own characteristics in symptoms, laboratory and pathology manifestations.

结果: MPA在 临床表现, 实验室检查,辅助检查及病理活检等方面各有特点.

互联网摘选

MPa and nearly horizontal, the jacking strength is about 6.

最小主应力状态为近水平; 测点洞段围岩的抗劈裂强度一般为6.

互联网摘选

Pressurize the vessel to e . g . 0.2 MPa ( overpressure ) and vent.

对反应釜加压如加压至0.2MPa ( 超压 ) 然后放空.

互联网摘选

Research results demonstrate that this consolidation technology can make the pressure of municipal wastes consolidates reach more than 38 MPa. And the consolidates durability is better, such as resistance of freeze and thaw, resistance of water, resistance of dry-wet circle and resistance of sulfate erode.

研究结果表明：本固结技术可使生活垃圾固结体28d强度达38MPa以上，其耐久性能诸如抗冻性能、耐水性能、抗干湿循环能力和抗硫酸盐侵蚀性能较为优越。

互联网摘选

The weldability of 800 MPa high strength steel has been studied with 20 mm and 42 mm thickness plates by the maximum hardness test of heat-affected zone, Y slit cracking test and the test of weld energy input etc.

采用热影响区最高硬度试验、斜Y型坡口裂纹试验及焊接线能量的测试等手段研究了板厚分别为20mm及42mm的800MPa高强钢的焊接性。

互联网摘选

A solvent-free room-temperature curable two-component PU adhesive was prepared, it has higher adhesion strengths and excellent toughness. The shear strength at room-temperature was 37.1 MPa and the shear strength at 200 ℃ was 3.8 MPa, and the tensile elongation at break still was 104%.

研制了一种室温固化无溶剂双组分聚氨酯胶黏剂，具有较高的黏接强度及良好的韧性，在保持室温剪切强度为37.1MPa的同时，扯断伸长率为104%，200℃仍有3.8MPa的强度；

互联网摘选

Through orthogonal tests, the optimized conditions for this dyeing process is obtained: pressure: 30 Mpa, temperature: 140 ℃, traverse: 5 mm and time: 90 min.

通过正交试验，优化出染色工艺条件：压力30MPa，温度140℃，动程5mm，时间90min。

互联网摘选

Another German MPA development ALIAS in EC countries application of good.

另外德国MPA开发的ALIAS在欧共体国家应用良好。

互联网摘选

METHODS Zedoary nano-liposomes were prepared by micro-jet technique ( jet dia . 50μ m, pressure 120 MPa ) .

方法采用微射流技术在射流直径50μm和压力120 MPa 条件下制备莪术油 纳米 脂质体制剂.

互联网摘选

Dongguashan copper mine has such characteristics as high stress ( 30~38 MPa ) and rockburst possibility.

冬瓜山铜矿深井具有高应力 ( 30~38MPa)、存在岩爆倾向的特点.

互联网摘选

Conclusion The results show that MPA can be useful to various tumors in impoving life quality.

结论甲孕酮(MPA)可以广泛用于各种肿瘤的化疗期间,来改善患者生活质量.

互联网摘选

The recovery of CO _ 2 injection core displacement is 48.15 % at 22.64 MPa.

芳48断块岩心在22.64MPa下注CO_2采收率为48.15%.

互联网摘选

So this model is not applicable when pressure is above 3.8 MPa.

因而,该模型不能应用到3.8MPa以上的高压力范围.

互联网摘选

The ore-forming pressure was small , ranging from 5 to 30 MPa.

热液压力不大,变化在5—30MPa之间.

互联网摘选

For MPP , MPH, MPA series S-correction capacitor, the permissible lp-p value is also listed.

MPH 、 MPA系列S校正电容器给出了额定峰峰值电流.

互联网摘选

The results show that 60 MPa increment of tensile strength of big bar and forge can be obtained when the annealing temperature grows up.

结果表明：大规格棒材、锻件的强度随退火温度升高而提高，升幅在60MPa左右。

互联网摘选

The study depicts the process of tetramethyl ammonium hydroxide pentahydrate and isopropyl alcohol azeotropic in the case of negative pressure 0.1 Mpa for 4h, and then dried by vacuum.

实验研究了在负压0.1MPa的情况下，五水四甲基氢氧化铵与异丙醇共沸4h，然后减压真空干燥得到四甲基氢氧化铵三水结晶化合物的过程。

互联网摘选

Cell surface Fas expression in cancer cells increased after treated with MPA.

MPA作用后结肠癌细胞表面Fas表达 显著增强.

互联网摘选

Under the pressure of 0 6 MPa, reacting for 3 h at the temperature 55-90 ℃, the conversion of tetraethylene glycol was greater than 99% and the selectivity of dimethyl ether was 786%.

反应温度为55～90℃，反应压力06MPa，反应时间为3h，四甘醇转化率大于99%，双醚选择性为786%。

互联网摘选

The compressive strength was as high as 350 MPa.

抗压强度高达350MPa以上.

互联网摘选

Quenching tempering technological parameter for 590 MPa High strength thick steel plate

590MPa高强度厚钢板的调质工艺参数研究

互联网摘选

The scraper coating requires: high solid content and good theologic property, that is, low viscosity, generally less than 500 mpa.

刮刀涂料要求固含量高，流变性能好，即粘度低，一般小于500mpa。

互联网摘选

For methane/ ( water+ active carbon) system, methane gas storage capacity in hydrates was quite close to theoretical maximum value at the pressure range of 5.7~ 9.5 MPa and the temperature range of 275.8~ 280.0 K for some runs.

在甲烷/（水+活性炭）体系中，5.7～9.5MPa和275.8～280.0K时，一些水合物储气量的实验值已接近最大理论值，这是由于活性炭能为水和甲烷提供优异的接触条件。

互联网摘选

According to experimental results, the early stage strength index should be 18.5～26 MPa.

根据试验结果, 该龄期强度值应在18.5～26MPa之间.

互联网摘选

Study of Rolling Process on Non-quenched and Tempered Steel with Tensile Strength of 600-800 MPa

600~800MPa级非调质钢的轧制工艺研究

互联网摘选

Amphoteric polyacrylamide as paper reinforcer was synthesised with G-acrylamide , acrylic acid , nitrile, accelerant-MPA as raw materials.

以丙烯酰胺、丙烯腈 、 丙烯酸和促进剂MPA为原料合成两性聚丙烯酰胺纸用增干强剂,并讨论了各反应条件对产品性能的影响.

互联网摘选