1、

Fatigue anchor property of compound body from unbonded prestressed tendons and anchorage device under low temperature

无粘结预应力筋&锚具组装件在低温下的疲劳锚固性能

互联网摘选

2、

Micro-hardness test and XRD spectra indicate that artificial ageing treatment at low temperature can further improve the mechanical property of the solid solution strengthening aluminum alloy after ECAP process.

显微硬度以及XRD测试结果显示低温时效处理进一步提高了强化固溶态高强铝合金ECAP加工后的机械力学性能。

互联网摘选

3、

The thesis analysis is made on the crimp property of polyester/ modified high shrinkage polyester conjugated fiber. The crimp property of three kinds of conjugated fiber in different conditions such as heat processing ways, temperature and time is tested.

对聚酯/改性高收缩聚酯复合纤维的卷曲性能进行了理论分析,并测试了不同组分比例以及不同热处理方式、温度、时间条件下的聚酯/改性高收缩聚酯复合纤维的卷曲性能。

互联网摘选

4、

The manufacture of corn starch binder is studied, which is made in hot state and used in room temperature, and the factor affecting its binding strength and compare the binding property with water glass.

本文研究了热制冷上机玉米淀粉粘合剂的制造工艺与影响其粘合强度的因素,并与水玻璃做了粘合性能的比较。

互联网摘选

5、

Results showed appropriate boric oxide would improve the tensile strength of SiO2-Al2O3-MgO fiberglass, and perfect the processing property through reducing the high temperature viscosity of the glass.

其中引入氧化硼的研究结果表明,氧化硼引入量从1wt.%增加到2wt.%时可提高硅铝镁系高强玻纤拉伸强度200MPa左右,通过降低玻璃液的高温粘度为其工艺性能的改善提供了可能。

互联网摘选

6、

Using a proportional tube, we measured the gas gain property of the helium-based gas mixture He/ C3H3 ( 60/ 40) with 55Fe as a function of high voltage ( linear density of the anode wire), temperature, gas pressure and gas ratio.

利用正比计数管和55Fe源对氮基混合气体He/C3H2(60/40)的气体增益随高压(阳极丝线电荷密度)、温度、气压及气体比分的变化作了实验研究。

互联网摘选

7、

Study on Dielectric Property with Temperature Based on the Molecule Simulation Technique

基于分子模拟的二氧化硅介电常数温度特性规律的研究

互联网摘选

8、

Effect of Environment Temperature on Torsion Property of EIPS Steel Wire

环境温度对四级钢丝扭转性能的影响

互联网摘选

9、

At a low temperature, the mechanical property improving, residual stress, roughness & cutting tool wear decreasing.

低温状态下金属材料表现为机械性能提高, 残余应力下降, 粗糙度降低 、 刀具磨损减小.

互联网摘选

10、

Research on creep property of SGC specimens in high temperature

旋转压实试件的高温蠕变特性研究

互联网摘选

11、

In this paper, the corrosion property of NZS system decorative copper alloy under different plastic deformations is investigated, and the influences of grain size and annealing temperature upon the corrosion property discussed.

着重研究了NZS系列装饰铜合金在不同塑性变形下的腐蚀性能。同时对晶粒度、退火温度对腐蚀性能的影响做了一定的探讨。

互联网摘选

12、

Excellent anti-scuffing property gives special protection where high speed, high pressure and temperature conditions are experienced.

极佳的抗磨损特性,令机件在高速, 高压和高温之下能有效地受到保护.

互联网摘选

13、

The elevated temperature strength and creep property of alloys can be improved by the Sr addition.

锶合金化可以改善镁合金的高温力学性能以及蠕变性能.

互联网摘选

14、

Fine M/ A was favorable for low temperature toughness. Offshore platform plate had excellent toughness and anti-lamellar tearing property.

细小的M/A岛有利于改善低温韧性;试制钢板具有良好的强韧性和抗层状撕裂性能。

互联网摘选

15、

though temperature an emergent property, it can be measured precisely, confidently, and predictably.

尽管温度也是涌现出来的特征, 但它仍然可以被精确 、 肯定地测量出来, 甚至是可以预测的.

互联网摘选

16、

This technology test presentation is about procedure test of weld joint property of Cr-Mo steel through normalizing heat treatment, including the tensile strength and impact toughness under low temperature.

介绍了正火处理的Cr-Mo钢焊接接头性能的工艺试验情况,重点探讨了焊接接头抗拉强度和低温冲击性能的影响因素。

互联网摘选

17、

The effects of cooking temperature and time on the biochemical characteristics and textural property of Young Anchovy were investigated.

研究了不同热煮温度及时间对丁香鱼生化特性和质地的影响。

互联网摘选

18、

In this paper, based on some property in digital image and the theory on the application of partial differential equations in image processing, we take the pixel values of an image as the temperature of some plane object.

在分析一些常见的图像放大方法的基础上,根据图像像素值特点及近期偏微分方程在图像处理中的应用,将图像的像素值看作是平面物体的温度;

互联网摘选

19、

The synthesis technology for PET/ nano-meter clay ( NCL) composite was studied, and the effects of NCL on the polymerization of PET/ NCL, the deformation of PET slice, the phase transition temperature and the gas barrier property were discussed.

研究了聚对苯二甲酸乙二醇酯(PET)/纳米累托土(NCL)复合材料的合成工艺,讨论了NCL对PET聚合工艺、切片的形变和相变温度以及气体阻隔性能的影响。

互联网摘选

20、

The main methods of direct rolling technology for conventional wide strip mill in Europe and America are analyzed. The speed, temperature compensation, buffer. process control and property prediction, etc.

分析了欧美直接轧制技术的主要对策,针对速度补偿、温度补偿、缓冲,过程控制和性能预报等措施加以论述,提出可行的直接轧制方案。

互联网摘选

  • 今日热词
  • 热门搜索

英语网英语词典(dict.25820.com)为您提供在线翻译英语词典单词大全英译汉汉译英等英语服务!可按单词字数词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈