1、

Therefore, it is necessary to raise the gas volume rate while keeping the gas slot width and the casting speed at appropriate levels so as to improve slab quality.

为此,连铸过程中必须采用合适的气缝宽度和拉坯速度,尽可能地增大气体流量,以提高连铸坯质量。

互联网摘选

2、

In this paper, the method to calculate the pole arc coefficient is got. ( 3) The reduction method of cogging torque by different slot width pairing is studied.

本文分析了平行充磁永磁直流电机极弧系数对齿槽转矩的影响,得到了极弧系数的确定方法。(3)分析了不等槽口宽配合削弱齿槽转矩的方法。

互联网摘选

3、

Analyzing the degree of the parameters influencing on heat transfer performance of heat pipe, they are wick diameter, groove number, the slot width and the vapor core diameter.

分析得到了各参数对热管传热性能影响程度,由大到小的顺序为槽道直径、槽道数目、窄缝宽度和蒸汽腔直径。

互联网摘选

4、

According to the above algorithm, the paper analyzes the effect of the slot width ( a), length ( b), and depth ( h) on SE and presents its varying graph;

采用上述算法研究孔缝宽度(a)、长度(b)、深度(h)对SE的影响,给出了SE随a、b、h的变化曲线图;

互联网摘选

5、

Some parameters affecting the supersonic flowfield, including the total pressure ratio of jet to freestream, slot width of injection, and the angle of injection were studied in more detail.

探讨了射流/主流总压比、射流宽度、以及射流与来流夹角对射流穿透深度、分离距离等影响,揭示了二次射流推力矢量控制干扰流场的控制机理。

互联网摘选

6、

If other factors remained unchanged, the hole diameter and the slot width increased with decreasing laser energy intensity and increasing nozzle diameter, the machining surface is not plan and the machining depth are slow.

当其它试验条件不变时,喷嘴直径越大,水导引激光能量密度越小,加工孔径和槽宽越大,加工深度越浅,加工的表面质量越差。

互联网摘选

7、

Through the lubrication theory modeling, the paper has studied the influences of such technological parameters as gas volume rate, gas slot width and casting speed on the gas film pressure distribution in the gas film soft-contace continuous casting technology.

通过建立铝合金气膜软接触连铸工艺润滑理论模型,分析气体流量、拉坯速度、气缝宽度等参数影响结晶器内气膜压力分布的规律。

互联网摘选

8、

Two formulas of compound shaper cutter are ob-tained. They are used to calculate the pitch pressure angle of chamfer involute and radius of circle on which chamfer involute starting point lies, and to check the tooth root slot width.

得到了复合插齿刀倒角渐开线分度圆压力角,倒角渐开线起始点所在圆半径的设计公式及插齿刀齿根槽宽的验算公式;

互联网摘选

9、

RELATION BETWEEN MAGNETIC LEAKAGE FIELD YIELDED BY A SLOT WITH SLOT WIDTH AND LIFTING OFF& Principle of magnetic particle inspection, Part XLI

沟槽所生漏磁场与槽宽和提离的关系&磁粉探伤原理之四十一

互联网摘选

10、

Taking water as examples, the velocity of the flow are numerically calculated, and the influences of slot width, slot depth, slot interval and slot number on the velocity distribution are analyzed, respectively.

以水为例,对这种流动的速度进行了数值计算,并分析了槽宽、槽深、槽间距及槽数对速度分布的影响。

互联网摘选

11、

Using CCD censor to receive the Laser diffraction and measure the precise slot width and round hole radius

利用CCD接收激光衍射的方法测量精密缝宽和圆孔直径

互联网摘选

12、

to broach points crumbs slot with design, calculation, slot width chip runs the number of slots crumbs.

再对拉刀分屑槽进行设计,分别用公式计算出分屑槽宽、分屑槽的个数。

互联网摘选

13、

To broach points crumbs slot with design, calculation, slot width runs the number of slots crumbs.

再对拉刀分屑槽进行设计, 分别用公式计算出分屑槽宽 、 分屑槽的个数.

网络文摘精选

14、

Transverse distance of containers according to a slot width of 2580 mm.

集装箱之间的横向距离是根据箱位宽度2580毫米而定.

网络文摘精选

15、

The factors considered were jet velocity, spacing of nozzle-to-impinging plate ( height), slot width, angle between jet direction and plate, temperatures of impinged plate and water ( liquid) from the slot nozzle.

考虑冲击区对流换热的因素有射流的速度、射流出口距冲击板的距离(高度)、喷嘴的宽度、射流出口速度方向与冲击板之间的夹角、冲击板的温度及水温等。

互联网摘选

16、

These analytical results show that the change of the slot width and pole pitch affect the performance of the motors greatly. It also demonstrates that skewing poles could efficiently decrease the torque ripple of PM motors.

分析结果表明,定子槽宽和极宽的变化会对电机性能产生较大影响,永磁电机采用斜极结构,可有效减小电磁转矩波动。

互联网摘选

17、

A lower water removal efficiency is obtained for slot width in the range 1.0~ 1.5 mm.

在本实验条件下,相应去水效率较低的缝隙宽度为10~15mm。

互联网摘选

18、

Under the present test conditions the slot width associated with a relatively low efficiency of moisture removal is found to be 1.0-1.5 mm.

存在一个去水效率较低的缝隙宽度范围,在本试验条件下,相应去水效率较低的缝隙宽度为1.0~1.5mm;

互联网摘选

19、

An Experimental Study about Relationship between Slot Width and Static Pressure Distribution on Bridge Deck Surface

桥面槽缝对桥梁断面静态压力分布影响的实验研究

互联网摘选

20、

Influence of Steam Extraction Slot Width on the Flow Fields of Neighboring Steam Turbine Stages

汽轮机抽汽缝宽度对邻近透平级流场的影响

互联网摘选

  • 今日热词
  • 热门搜索

英语网英语词典(dict.25820.com)为您提供在线翻译英语词典单词大全英译汉汉译英等英语服务!可按单词字数词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈