radius die的例句大全

Push bending process and die with variable radius for rectangle tube

矩形管变曲率推弯工艺与模具

互联网摘选

The springback angle increases with the increase of the punch round radius and clearances between the punch and the die while decreases with increase of the blank holder force, sheet thickness, friction coefficient and material hardening exponent.

回弹角随凸模圆角半径和凸凹模间隙的增大而增大，随压边力、板料厚度、摩擦系数和材料硬化指数的增大而减小。

互联网摘选

NIB: Green roller defect on the small end radius; caused by taper die failure. A sharp protrusion on the small end of the roller.

由于圆锥模具缺陷造成的半成品滚子小端倒角缺陷，滚子小端有尖锐的突出。

互联网摘选

The determination of the minimum bending radius in the design of the pipe_bending die was stated. And the structure of the die slot, the form and installation of the shaft core were introduced. The pipe was prevented effectively from deformation.

叙述了弯管模设计中最小弯曲半径的确定，弯管模模槽的结构，芯轴的形式和安装，有效地防止管子变形，并通过实践经验给出了一些模具设计参数。

互联网摘选

The friction behaviors in the flanges area and die corner radius area during the variable forming speed/ forming loading stamping process are studied by flat plate friction test and stretch bending friction test.

为此，针对拉深成形，分别采用平板滑动摩擦实验和拉弯摩擦实验，研究了变速/变载条件下板料在法兰处和凹模圆角处的摩擦行为。

互联网摘选

An optimum combination of forming parameters of expanding-ratio, diameter of sectorial die and corner radius of die rim is concluded from a functional relation between roundness error of cross-section and forming parameters for the process of mechanical expanding of large diameter line pipe in the paper.

针对大直径管线钢管机械扩径工艺，得到了以最终制品形状精度（横断面圆度误差）为优化目标的扩径率、模具直径和模具边缘圆角半径等成形参数的最优组合。

互联网摘选

the results indicated that the mainly strain at the die corner was shearing strain and the existence of the oblique radius widened the deforming area.

结果表明，在模具转角处主要发生剪切变形；通道内侧倒角的存在使变形区宽化。

互联网摘选

In the process of exploitation, we use a new idea of "pitch cone radius not modification, reference cone angle modification." and order function of "Program" of Pro/ E system to reach parametrical control of assembles of die.

在开发过程中，利用节锥不变、分锥变位的新思路和Pro/E系统中的Program命令功能达到模具组件的参数化控制。

互联网摘选