load area的例句大全

The design structure of pressure vessel, suspension of boiler proper. strengthen of local load area on shell, FEA calculation and manufacture of 60 t/ h PFBC are described in the paper.

介绍了60t／h增压流化床锅炉压力壳的设计结构、锅炉本体的悬吊方法、壳体上局部载荷区的加强、有限元应力计算以及制造工艺特点。

互联网摘选

In this paper, the load which the bolster plates transmit in hydraulic press are analyzed by finite element method with plane stress elements. The results of calculation show the effect of bolster plate height and load area on transmission of load.

采用平面应力单元，对水压机加载时垫板对载荷的传递进行了有限元分析，得到了垫板高度以及加载区域对力的传递的影响规律。

互联网摘选

Today, the capacity of the water turbo-generator set is larger gradually. The phenomenon of excessive vibration in some load area is founded ubiquitously.

目前，水轮发电机组的容量和尺寸日趋增大，普遍出现在某些工作区域内机组振动过大的现象。

互联网摘选

The results showed that the accuracy of this model is high in mid engine load area and its error is limited in useable range.

结果表明，该模型在发动机中负荷区域预测精度较高，其误差在使用允许范围内。

互联网摘选

An Analytical Study on Consolidation Settlement Characteristics of the Sand Drain ( Wall) Subgrade under Embankment Load at Soft Soil Area

软土地区路堤荷载作用下砂井（墙）地基固结沉降特性分析研究

互联网摘选

However, for the composite load has the characteristics of complex composition, random time variance and spread over different area, its exact mathematics model is still not built up.

然而，系统中的综合负荷，由于具有构成复杂、随机时变、地域分散等特点，其准确的数学模型一直没有建立起来。

互联网摘选

Testing Study of Load Transfer Behavior of Friction Piles in Soft Rock Area of Guizhou Province

贵州软岩地区摩擦桩试验研究

互联网摘选

What is the safe working load of the bitts in the bow area?

船首区域缆桩的安全工作负荷？

provided by jukuu

Modern backpacks spread the load over a wider area.

新式背包把承重量分散在更大的面积上。

《牛津高阶英汉双解词典》

The factors, as heat load, axial tilt angle, lateral tilt angle and heating area, on the FHP performance have been studied. The thermal conductivity ratio and its combination parameter with the density of different FHPs have been compared.

研究了加热功率、轴向倾角、侧向倾角和加热面积等因素对热管传热性能的影响，比较了不同实验件的导热系数和其与密度的组合参数。

互联网摘选

By employing a relatively detailed thermal load time retardation chart with the unit heat supply area net value of the nuclear heat supply system assigned as an optimization objective, an optimization of the nuclear heat supply plant thermochemical factor was conducted.

利用较详细的热负荷延时图，以核供热系统单位供热厂热面积净现值为优化目标，对核热电化系数进行优化。

互联网摘选

Analyzing Load Characteristic Earnestly to Enhance Area Load Rate

认真分析负荷特性，提高地区负荷率

互联网摘选

The Strategy Research of Area Control Errors Under Disturbed Load and Tie-lines Control

区域控制误差在扰动负荷及联络线控制中的策略研究

互联网摘选

As compared to montmorillonite, the total surface area, micro-pore surface area and micro-pore volume of copper-loaded montmorillonite are reduced, while the cation exchange capacity, external surface area, pore volume and pore diameter are increased.

与蒙脱石相比，载铜后的蒙脱石总比表面积、微孔比表面积、微孔体积减少，而离子交换容量、外比表面积、孔体积和孔径增大。

互联网摘选

The theoretic calculation and experiment states that the horizont al roller load is light at open pass area and heavy at the close pass and sizing area.

理论计算和实验对比表明，水平辊的负荷在开口区比较小，而在闭口区、定径区则比较大。

互联网摘选

It is shown that, static load has evident effects on stress of tire cord in ground contact area;

结果表明，静负荷对轮胎接地区域内帘线受力影响显著；

互联网摘选

To improve the load space area, the wheelbase is extended to86 inches while a new long wheel base Pick Up version and a Station Wagon appear.

为了改善负载空间面积，轴距延长至86英寸，而新的长轴距提货版和旅行车出现。

互联网摘选

The haet exchange area and quantity of heat exchanger are decreased for the same thermal load, compared to the common heat exchanger.

在相同热负荷下，与传统换热器比较，空心环缩放管式换热器换热面积和质量均有很大幅度的减少。

互联网摘选

Furthermore, the technology of wireless spectral resource management includes many sub-areas such as allocation of spectrum, wireless admission control strategy, layer-selection of HCSs, handoff technology, load balancing, power control and capacity analysis and so on.

而且，无线资源管理技术所涉及的领域也是非常广泛的，包含了无线资源分配、呼叫接纳控制、小区层选、小区切换、负荷控制、功率控制和容量分析等领域。

互联网摘选

It is different from under point contact that there is no stick area under line contact in the partial slip regime, and load distribution within line contact area is uneven due to roughness of surface.

磨痕分析表明，承载区域接触不均匀，存在虚接触区域，其大小与表面粗糙度有关，而接触区域没有不磨损的粘着区，不同于点接触形式。

互联网摘选