1、

A model of microwave loss due to spin wave resonance in grain surface layers

微波铁氧体损耗的晶粒表层自旋波共振模型

互联网摘选

2、

Further increasing the substrate temperature broadens the band tail width of the films because the hydrogen content is too low to passivate the dangling bonds at the NC silicon grain surface.

对应更高的衬底温度,因薄膜中的氢不能完全中止纳米晶粒界面的悬键,使薄膜能带带尾加宽。

互联网摘选

3、

Test of insulation heat of grain surface in large warehouse

高大房式仓粮面压盖隔热试验

互联网摘选

4、

aluminium phosphide natural deliquescence circling fumigating trial on grain surface

磷化铝粮面自然潮解环流熏蒸试验

互联网摘选

6、

Can increase genuine leather's transverse tear strength, grain surface crack intensity and tensile stretch after using.

使用后可有效增加真皮的抗撕裂强度 、 粒面崩裂强度,还可增加真皮的伸长率.

互联网摘选

7、

In order to ensure solid motor with cracked grain to be successfully launched, the strain and stress concentration at the tips of crack should be released by shoveling slot on the crack of grain surface.

工程实际中通常采用于药柱表面裂纹处铲槽的方法来释放裂纹尖端的应力应变集中,以确保药柱含裂纹的固体发动机能正常点火发射。

互联网摘选

8、

Environment-friendly thick film conductor paste adopts ultrafine Pd-Ag alloy powder made by chemical methods as functional phase. Alloying is complete. Average grain is 0.1 μ m and specific surface area is 10m2/ g.

环保型厚膜导体浆料,采用化学法制超细钯银合金粉作功能相,合金化完全,平均粒度0.1μm,比表面积10m2/g;

互联网摘选

9、

The surface of the residue grain showed poriferous and lax structure.

大部分颗粒表面呈多孔、疏松结构。

互联网摘选

10、

Research on surface and grain boundary passivation mechanism obtained effects of surface recombination on crystalline silicon solar cell performance and the theoretical expression of grain boundary recombination velocity.

钝化机理研究获得了表面复合对不同表面掺杂浓度晶体硅太阳电池性能的影响、表面和界面复合速度的理论表达式;

互联网摘选

11、

The decreased grain size increases the surface spin disordered state and the resistivity which originates from the strengthened scatter of the spin correlation electron at the grain boundary, but reduces the Curie temperature.

随着晶粒尺寸的减小晶粒表面处的自旋无序增多,使居里温度降低,同时使自旋相关电子在晶界处的散射增强,提高了材料电阻率。

互联网摘选

12、

Because the grain is little in full tailings, angle of beach surface slope become very smooth near the gateway, and the flow is very slow. Remain the slowly sliding flow, so angle of beach surface is about 0.3%.

但由于全尾矿中这种颗粒少,离放矿口不远处的滩面坡度就变的很平缓,流速很慢,维持这种缓慢滑移流动的滩面坡度约为0.3%。

互联网摘选

13、

The deep and large cavities are formed on fracture surface and grain boundary sliding and intergranular fracture characteristic is obvious on the optimal superplastic deformation condition.

在最佳超塑性条件下,断口中形成了大而深的空洞,晶界滑动和晶间断裂特征明显。

互联网摘选

15、

Grain shape and surface roughness are indicated to codetermine the abrasion resistance of the film. Further, the AR film with triangular grain and moderate roughness shows good abrasion resistance.

分析得到了粗糙度与耐磨性关系曲线,结果表明三角形晶粒以及适中的粗糙度能有效的提高薄膜耐磨性。

互联网摘选

16、

On the basis of core observation, grain analysis and the other data, the work area develops abundant tempestites, and the main types of tempestite sedimentary characteristics have been identified, including truncated structure, gutter cast, hummocky cross-stratification and scouring surface.

根据岩心观察和粒度等资料,工区内发育有丰富的浅湖风暴沉积,主要有截切构造、渠模、丘状交错层理和冲刷面等典型的风暴成因构造。

互联网摘选

17、

Study on Surface Characters of Engineering Ceramics Honed by Coarse Grain Diamond

粗磨粒金刚石珩磨工程陶瓷的表面特征研究

互联网摘选

18、

The surface grain size and thickness of scale vary with temperature, and the initial wear loss increases with increasing grain size, and same tendency is observed for the total wear loss vs the thickness of scale.

膜表面晶粒大小和厚度随着温度而变化,膜初速磨损量和总磨损量随着成膜温度的变化分别与表面晶粒大小和膜厚相对应;

互联网摘选

19、

The results show that the nanograined microstructure with the average grain size of obout 20 nm is obtained in the surface layer of this steel by high-energy peening process. The phase constitute is not changed. The hardness of the peened sample is increased by about 21.5%.

实验表明,含氮中锰奥氏体耐磨钢经高能喷丸处理后,可获得平均晶粒尺寸约为20nm的纳米晶组织表面层,表层相组成没有变化,喷丸后硬度提高了约21.5%。

互联网摘选

20、

Effect of Grain Size of Grinding Wheel on Surface Topography

砂轮粒径对磨削后Si片表面形貌的影响

互联网摘选

  • 今日热词
  • 热门搜索

英语网英语词典(dict.25820.com)为您提供在线翻译英语词典单词大全英译汉汉译英等英语服务!可按单词字数词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈