flexural modulus的例句大全

when the content of the mmt was 5%, a heat deformation temperature of 154 ℃ and a flexural modulus of 3.335 gpa of the nanocomposite were obtained.

对其力学性能和热性能的分析发现，当有机化蒙脱土用量为5%（质量含量，下同）时，材料的热变形温度及弯曲模量分别达到154℃和3.335GPa。

互联网摘选

meanwhile the tensile strength and flexural modulus of ipp could be increased by about 10% and 30%, respectively, and the haze value of ipp could be decreased by about 40%.

同时可使聚丙烯的拉伸强度提高10%左右，弯曲模量提高30%左右，雾度降低40%左右。

互联网摘选

analysis and calculation for flexural modulus of symmetric multiply laminates study of the nonlinear forced flexural vibration of anisotropic composite symmetrically laminated plates

对称多层粘合板弯曲模量的分析计算各向异性复合材料对称角铺设层合板非线性弯曲强迫振动

互联网摘选

with further increasing the epoxy resin content, the flexural modulus and tensile strength increase slowly and the impact strength varies slightly, while the elongation at break decreases rapidly.

继续增加环氧树脂的含量，共混物的拉伸强度和弯曲模量增加缓慢，冲击强度无明显变化，断裂伸长率进一步降低。

互联网摘选

with content of silk fibroin of the sample increased, compression modulus and flexural modulus decreased gradually in the trend, when the content is less than 50%, the downward trend even more pronounced.

随着样品中丝素蛋白含量的增加，压缩模量及弯曲模量呈逐步下降趋势，当含量小于50%时，下降趋势更为显著。

互联网摘选

The cement stabilizing aggregate mixture including the base course binder with high added GGBS have higher compressive strength and flexural strength, crack coefficient, smaller compressive modulus, flexural modulus and better drying shrinkage coefficient than cement stabilizing aggregate mixture with P.

用高掺量矿渣稳定的碎石，其无侧限抗压强度和抗折强度高，回弹模量小、收缩系数小及抗裂性能好，各项性能均优于参照对象&P·O32.5水泥稳定土。

互联网摘选

Results indicated that the integrated mechanical property of HDPE/ E-TMB blends was best with notched izod impact strength increasing 5.65 times, retention rates of tensile yield strength and flexural modulus being respectively 90.8% and 73.7% when elastomer content of E-TMB was 44%.

结果表明，当E-TMB中弹性体含量为44%时，共混物的综合力学性能最好，悬臂梁缺口冲击强度是HDPE的5.65倍，拉伸屈服强度和弯曲弹性模量保留率分别为90.8%和73.7%；

互联网摘选

the experimental results indicated that with the increasing of vf, the compressive strength decreased, and compressive, flexural modulus increased.

实验表明：随着V f的增大，材料压缩强度减小，压缩模量和弯曲模量增大；

互联网摘选

this article indicates some defects in the old standard, analyses the developments in the new one, and also points out the method to improve the accuracy of flexural modulus.

对新老标准中有关弯曲模量的计算方法进行了比较分析和探讨，并对如何提高数值的精确度提出了几种方法，为更好地理解和实施新标准作了一些补充。

互联网摘选

results showed that as the hardness of modified epdm increased the brittle-ductile transition moved to high rubber contents and the flexural modulus increased profoundly, however.

结果表明：随着EPDM硬度的增加，共混物不仅韧性提高，弯曲模量也大幅度上升。

互联网摘选

standard test method for flexural modulus of elasticity of dimension stone

方石弯曲弹性模量的标准试验方法

互联网摘选

test method for flexural modulus of elasticity of dimension stone

规格石材弯曲弹性模数的试验方法

互联网摘选

experimental results show that the flexural modulus increases with the increases of the fibre content and length.

实验表明，随着纤维含有量和纤维长度的增加，材料弯曲模量呈递增趋势。

互联网摘选

meanwhile the tensile strength and flexural modulus of ipp were not significantly affected.

同时对聚丙烯拉伸强度和弯曲模量没有明显的影响。

互联网摘选

the results show that the synthesized polymers possess both high impact strength and flexural modulus.

研究结果表明，开环歧化交联聚双环戊二烯是一种兼具较高模量、高冲击强度的结晶性高聚物。

互联网摘选

three points bending test results show that there is an increase in flexural modulus with reinforcement contents.

三点弯曲试验表明，随着增强物的增加，弹性模量也增加。

互联网摘选

prediction of flexural modulus and preparation of bagasse fiber-reinforced biodegradable composites

甘蔗渣纤维增强可降解复合材料的制备与弯曲模量的预测

互联网摘选

improves polypropylene's m.f.i, flexural modulus and impact strength.

改进聚丙烯的M.F.I、弯曲模量和冲击强度等指标。

互联网摘选

the results show that impact strength and flexural modulus of glass fiber/ polypropylene increase greatly using the copolymer coupling.

结果表明：采用大分子偶联剂处理玻璃纤维可使玻纤毡/聚丙烯复合材料冲击强度和弯曲模量都得到很大程度的提高。

互联网摘选

compared with common nucleating agent sodium benzoate, nacl/ peo had a better nucleating effect and accelerated the crystallization of pet, and the composites with nacl/ peo had higher flexural modulus and better surface gloss.

与常用的成核剂苯甲酸钠进行了比较，发现NaCl/PEO具有比苯甲酸钠更好的成核效果和促进结晶作用，制得的复合材料具有更高的模量和更好的表面光洁度。

互联网摘选