bending modulus的例句大全

Expounded punching, blanking, bending modulus of the composite structure design and principle.

阐述了冲孔 、 落料 、 压弯复合模的结构设计及工作原理.

互联网摘选

the equation gives the value of the bending stress at any distance v from the neutral axis.

此式给出了至中性轴任意距离V处的弯曲应力值。10.Bending modulus of elasticity, bending moment and bending stress were lower in the model group than in the normal control group (P 05).模型组弯曲弹性模量、弯矩、弯曲应力低于正常对照组（P0.05）。

互联网摘选

The relationship between bending modulus of elasticity and bending strength was also linear.

抗弯弹性模量与抗弯强度具有密切的线性关系.

互联网摘选

For GB/ LLDPE composites extruded by single screw extruder, with the increase of filler content, the tensile modulus, bending modulus increased linearly, while the yield strength and bending strength increased slightly at higher filler content.

而GB/LLDPE中，随着GB用量的增加，单螺杆挤出复合材料的拉伸模量、弯曲模量均呈线性增长趋势，而屈服强度和弯曲强度在含量较高时略有上升；

互联网摘选

Bending modulus of CF/ KF hybrid composites are on the rise with carbon fiber volume fraction increasing.

CF/KF混杂复合材料的弯曲模量随着碳纤维相对体积分数的增加而呈上升的趋势。

互联网摘选

Investigation of influence factors on bending modulus of carbon fiber/? Epoxy

碳纤维/环氧复合材料弯曲模量影响因素的研究

互联网摘选

Adding GF increased not only tensile strength and bending modulus but also impact strength of the composite.

GF的加入不但提高了材料拉伸强度、弯曲性能，而且提高了其冲击强度；

互联网摘选

The tensile strength and the bending modulus of RHDPE/ EVA/ MWRP blend increased by 35% and 25% respectively when the waste rubber powder was modified by self-made surface modifier ACDI.

废胶粉经自制表面改性剂ACDI预处理后，其相应的RHDPE/EVA/MWRP体系的拉伸强度和弯曲模量分别增加35%和25%，而对共混物的其它性能影响不大。

互联网摘选

For uniform isotropic materials, bending modulus of three point bending ( TPB) test and four point bending ( FPB) test are almost the same and they are almost equal to material ′ s tensile modulus.

对于均质各向同性材料，三点弯曲实验和四点弯曲实验得到的弯曲模量与拉伸模量基本上一致。

互联网摘选

The dynamic modulus of elasticity ( MOE) in bending of plywood was measured by tests of flexural vibration, longitudinal transmission and longitudinal resonant vibration.

通过弯曲振动试验、纵波传播试验及纵波共振试验对胶合板的抗弯弹性模量进行无损检测，并分析了三种试验方法测定结果之间的关系。

互联网摘选

Its producing area, exposed to the sun and measurement mode had a marked effect on bending strength, but affected modulus of rupture indistinctively.

毛竹的产地、生长朝向和测量方式均对弯曲强度影响较大而对弯曲模量影响则较小。

互联网摘选

The experiment shows that the retention of extension strength, bending strength and their modulus are above 60% below the 250 ℃, which has super high loading capacity.

实验表明，在250℃下其拉伸和弯曲强度及模量的保留率均在60%以上，仍具有极高的承载能力。

互联网摘选

Analysis of Equivalent Elastic Modulus of Single-Walled Carbon Nanotube Under Bending and Tensile Load

碳纳米管弯曲和拉伸等效弹性模量的计算分析

互联网摘选

three points bending test results show that there is an increase in flexural modulus with reinforcement contents.

三点弯曲试验表明，随着增强物的增加，弹性模量也增加。

互联网摘选

Effects of temperature and loading rate on the flexural-tensile strength, strain and stiffness modulus of ATB-25 asphalt mixture were discussed using three-point bending test.

通过沥青稳定碎石基层ATB-25沥青混合料的三点弯曲试验，研究了温度及加载速率对弯拉强度、弯拉应变及弯曲劲度模量的影响规律。

互联网摘选

test method for modulus of rupture in bending of electrode graphite

石墨电极芯挠曲断裂模数的试验方法

互联网摘选

modulus of rupture in bending

弯曲破坏模量

互联网摘选

In addition, there is positive correlation between fractal dimension and bending strength , bending elastic modulus.

另外, 发现分形维数与抗弯弹性模量 、 抗弯强度之间存在正相关趋势.

互联网摘选

With respect of bamboo, bending strength and modulus of rupture increased gradually from inboard bamboo inner place to outboard bamboo skin in the radial direction.

毛竹沿径向的弯曲强度和弯曲模量从最内层竹黄处向最外层竹青处逐渐增大。

互联网摘选

pure expanded corkboard; determination of the modulus of rupture by bending

纯膨胀软木板.弯曲断裂模数的测定

互联网摘选