bearings的例句大全

Based on his years of experience, the author tries to analyze the lubrication management for the main bearings of the? 2.2 × 6.5m cement mill from the viewpoint of technical maintenance.

作者试图结合自己多年的工作心得，并从技术维护的角度分析Φ2.2m×6.5m水泥磨主轴承的润滑管理。

互联网摘选

Linear Analysis of Thermal Instability of Oil Film of Thrust Bearings Under Conditions of Start-up Procedure

推力轴承瞬态启动油膜热不稳定性的线性分析

互联网摘选

Design and Application of Thin Section Bearings

薄壁轴承的设计应用

互联网摘选

Design of the Electrical Control System of Power Drive for 40t Thrust Bearings Test Station

4O吨推力轴承试验台主传动电控系统的设计

互联网摘选

Analysis of Temperature Factor of Two Dimensional Flowing Oil Film in Thrust Bearings with Tilting Pads

推力轴承二维流动油膜中的温度因子分析

互联网摘选

According to grease temperature and vibration of rolling bearings, the condition monitoring for rolling bearings was built.

并以轴承的振动和润滑脂温度为监测参数，建立了轴承状态监测系统。

互联网摘选

Application of fine sulphur concrete and mortar pro-portioning to the temporary bearings of bridge

细石硫磺混凝土及砂浆配制在桥梁临时支座上的应用

互联网摘选

At least one blade angle bearing of a pair of such bearings permits an axial movement of the respective tension or carrier bar, whereby the latter is able to take up bending loads.

至少有一个叶片角度轴承的一对，如轴承许可证的轴向运动各自的紧张或承运人的酒吧，而后者则是能够采取行动的弯曲载荷。

互联网摘选

The rubber bearings have stable mechanics properties when tension stress is no more than 3G.

结论工程设计中橡胶支座在拉伸应力不超过3G的条件下，支座具有稳定可靠的力学性能，确保隔震结构处于安全状态。

互联网摘选

And what I calculated was the terminal velocity as a function of radius of these ball bearings.

我计算的是终端速度，作为这些钢珠的，半径函数。

互联网摘选

And so notice that when you are at speeds above that that you are exclusively in domain two and your terminal speed is proportional to the square root of the radius of the ball bearings.

应当注意的是，当，速度大的时候，是在，区域2中，终端速度和，这些滚珠的，√r成比例。

互联网摘选

Research on Test Technology of Combinational Logic Circuits in the Control System of Magnetic Bearings

磁力轴承控制系统中组合电路测试技术研究

互联网摘选

Application of Spectrum Analysis in Failure Diagnosis of Bearings for Power Equipment

频谱分析在电力设备中轴承故障诊断的应用

互联网摘选

The Thermohydrodynamic Analysis of Finite Journal Bearings Lubricated with Pseudo-Plastic Lubricants

假塑性流体润滑有限宽向心轴承的热流体动力分析

互联网摘选

Therefore, the inlet pressure is very important in the analysis of the thermohydrodynamic performance of high speed light load thrust bearings.

因此，进口压力是分析研究高速轻载可倾瓦推力轴承热动力轴承热动力润滑性能中的一个不可忽略的重要因素。

互联网摘选

Thermohydrodynamic analysis of dynamically loaded bearings

动载轴承的非稳态热流体动力润滑分析

互联网摘选

Thermohydrodynamic calculation and analysis for main journal bearings in multi-cylinders ICE were made, which indicates that besides design parameters, practical complications also have influence on lubrication condition of main journal bearings.

对某多缸内燃机滑动主轴承的热流体动力润滑（THD）计算分析表明，除设计因素外，实际使用因素也对主轴承的润滑状况产生不良影响。

互联网摘选

This paper analyzes the nonlinear vibration characteristics and stability of a symmetrical rotor of single mass supported on multi-wedge bearings, and studies the cause and danger of the semi-frequency vibration, which may occur between the first critical speed and the stability threshold speed of the system.

本文分析了多油楔轴承支承的单质量对称转子系统的非线性振动和稳定特性，研究了临界转速与失稳转速之间半频振动产生原因及其危害性。

互联网摘选

The higher the speed should not adopt thrust ball bearings available class bearings are subjected to purely axial load.

在转速较高不宜采用推力球轴承的情况下可用该类轴承承受纯轴向负荷。

互联网摘选

Study on the task scheduling algorithm of the control systems of magnetic bearings

磁力轴承控制系统任务调度算法研究

互联网摘选