molecular dynamics simulation of the stretching process of silicon nano-rods

the newest research evolve of hollow produce stretching process

中空制品拉伸成型最新研究进展

互联网摘选

study on the transverse stretching process of bopp film

双向拉伸聚丙烯薄膜横拉过程探讨

互联网摘选

simulative analysis of stretching process of monolithic box beam

整体式箱梁张拉过程的仿真分析

互联网摘选

study on the stretching process of polyimide film

聚酰亚胺薄膜拉伸工艺的研究

互联网摘选

optimal control of stretching process of solar wings on spacecraft

航天器太阳帆板展开过程的最优控制

互联网摘选

comparison between plastic solid and liquid in the stretching process

塑性固体和液体拉伸实验的比较

互联网摘选

Numerical Simulation and Experimental Study of the Float Glass Stretching Process

浮法玻璃拉边过程的数值模拟及实验研究

互联网摘选

the optimal control problem of spacecraft attitude during its solar arrays stretching process is discussed in this paper.

本文讨论航天器太阳阵伸展过程中航天器姿态的最优控制问题。

互联网摘选

optimal control of stretching process of solar arrays on spacecraft using genetic algorithm

航天器太阳阵伸展过程最优控制的遗传算法

互联网摘选

ethanol, glycol, acetone, water and the mixture of acetone and water are employed as coagulating bathes, the optimum coagulating bath is confirmed by comparing the strength of resultant fibers.

采用乙醇、乙二醇、丙酮、水及其混合液作为凝固浴进行纺丝，通过对制得纤维的性能比较，确定了最佳凝固浴。

互联网摘选

the effects of resin type, temperature and dimethyl formamide ( dmf) contents in the coagulating bath, resin and filler contents in the coating solution, drying temperature in the baking oven on the properties 4| of the pu synthetic leather are discussed.

重点讨论了树脂种类、凝固槽温度和二甲基甲酰胺（DMF）浓度、涂布液中树脂和填充剂含量、烘箱的干燥温度等主要因素对PU人造革性能的影响。

互联网摘选

within mass fraction in coagulating bath of 10%~ 40%, as the mass fraction increases, the water flux of pes hollow fiber membrane first decreases, then increases and the degree of orientation first increases, then decreases;

结果表明：在凝固浴质量分数10%～40%的范围内，中空纤维膜的水通量先减少再增加；中空纤维的取向度则先增大后减小；

互联网摘选

about the effect of the type of spinning machine, the composition of coagulating bath and tanning bath as well as the spinning technological parameters on the strands strength, therefor, the relatively detailed discussion has been made.

因此，围绕着纺丝机的型式，凝固浴和鞣制浴的组成，以及纺丝工艺参数对丝强度的影响进行了较详尽的论述。

互联网摘选

the results show that spinning and fiber properties are influenced by the concentration of the solvent in the coagulating bath and the temperature of the coagulating bath.

结果表明：凝固浴中溶剂浓度对纺丝过程及纤维强度有重要影响，而凝固浴温度对纤维的影响相对较小；

互联网摘选

after the filaments are precipitated in the coagulating bath, the cellulose molecules may come out of the solution headed in any direction.

长丝在纺丝浴中凝固后，纤维素的分子会从溶液中析出。它们朝着不同的方向。

互联网摘选

influence of mass fraction in coagulating bath on structure and performance of pes hollow fiber membrane

凝固浴质量分数对聚醚砜中空纤维膜结构和性能的影响

互联网摘选

the experimental results indicated that low temperature of casting solution and coagulation bath, short evaporation time and low polymer concentration of casting solution tend to increase the effective porosity of membrane.

实验结果表明较低的铸膜液温度和凝胶浴温度、较短的蒸发时间和较低聚合物浓度有利于增加膜的有效孔隙率。

互联网摘选

sulfuric acid, ammonium chloride, sodium hydroxide and ethanol were selected as coagulation bath under different coagulation temperature and coagulation time to manufacture hec membranes.

分别选取硫酸、氯化钕、氢氧化钠和乙醇等溶剂作为凝固浴，在不同凝固温度和凝固时间下凝固制备HEC膜。

互联网摘选

in this thesis, we considered the theory of infinite dimensional stochastic evolution systems and its applications in modelling of formation mechanism in coagulation bath of carbon fiber precursor.

本论文致力于研究无穷维随机发展系统理论及其在碳纤维凝固浴成形机理中的应用。

互联网摘选

it was noted that when coagulation bath temperature was increased, crystallization could be suppressed, and more porous structure was obtained on the surface of the membrane.

另外，凝胶浴温度升高可以抑制结晶现象，并使膜表面孔径和孔密度增加。

互联网摘选