Operational Performance of Reactor with Gas Circulation and Its Application

1、

Transient Behavior Calculation for Reactor Coolant Circulation Pump

主循环泵瞬态特性计算

互联网摘选

2、

Iron oxide-mica pearlescent pigment was prepared from Fe ( CO) 5 in a spout fluidized reactor using metal organic chemistry vapour deposition ( MOCVD) technique.

以Fe（CO）5为物源，在常压喷动流化反应器中，以金属有机化学气相沉积（MOCVD）法对云母粉进行包覆，制备铁系-云母珠光颜料。

互联网摘选

3、

RSCAM program system, using Monte Carlo method with albedo approach, is used to calculate streaming neutron radiation field in reactor cavity and containment operating hall.

用具有反照率近似的蒙特卡罗方法编制的RSCAM程序系统计算反应堆堆腔内及安全壳操作大厅中的中子辐射场。

互联网摘选

4、

Program System for Calculating Streaming Neutron Radiation Field in Reactor Cavity

反应堆堆腔漏束中子辐射场计算程序系统

互联网摘选

5、

Cultivation of aerobic granular sludge in SBR reactor and its decontamination capability

SBR反应器中好氧颗粒污泥培养及其除污性能

互联网摘选

6、

Taking the typical three-tube co-current ammonia synthesis reactor in a middle-size ammonia synthesis plant of our country as an example, the mathematical models of the reactor were employed to simulate the reactor operation calculation.

以我国中型合成氨厂典型的三套管并流式氨合成反应器为例，采用反应器数学模型模拟反应器操作计算。

互联网摘选

7、

The design principle and methods of pre-treatment system and UASB reactor were emphasized. The discussion focused on concrete structure of UASB reactor, including dimension calculation and determination principle.

重点介绍了厌氧预处理工艺和UASB反应器的负荷设计原则和设计方法、混凝土结构矩形UASB反应器各个部分尺寸的计算和确定原则。

互联网摘选

8、

The work presented in this article is focused on the description of the fast-thermal coupled ADS subcritical reactor core and the calculation of the values of K_ ( eff) using the Monte Carlo code MCNP under various parameters of the reactor core.

文章主要是对快热耦合ADS次临界堆芯进行了描述，利用蒙特卡罗代码MCNP模拟计算一系列不同堆芯参数下的K eff值。

互联网摘选

9、

The Steady-State and Dynamic Behavior of the Fixed-Bed Catalytic Reactor for Fischer-Tropsch Synthesis CALCULATION OF PLATED UF DEVICE ON THE STABLE CONDITION

固定床F-T合成反应器稳态和动态行为

互联网摘选

10、

The possibility analysis of chemical explosion in the reactor and some concrete calculation were given, and then compared with the damage of the actual failure.

作者就尿塔内物料发生化学爆炸的多种可能性做了具体分析和计算，并与实际尿塔爆破事故所产生的破坏程度进行了比较。

互联网摘选

11、

The reactivity effects were compared between unit mass nuclear waste element MA and uranium element on the fast neutron reactor model by simulating calculation.

在快中子反应堆模型上，用MC方法模拟计算和比较单位质量MA核素和易裂变核素引起的反应性变化。

互联网摘选

12、

Finally, the kinetic equation applied to cracking reactor optimization and simulation calculation, which could be used for industrial reaction debugging and reference.

最后将动力学方程应用于裂解反应器的优化与模拟计算，可用于为工业裂解反应的优化操作提供理论指导。

互联网摘选

13、

The Resonance Stirring Reactor and Its Vibration Calculation

共振搅拌反应器及其振动计算

互联网摘选

14、

The anti-seismic analysis is carried out for dry-type air-core reactor. The calculation basis and mathematic model are given. The basic natural vibration period, seismic stress and the calculating formula for safety-check are all presented here.

对干式空心电抗器总称结构进行了地震分析，提出了计算依据与数学模型，给出了基本自振周期、地震力以及安全校核的实用计算公式。

互联网摘选

15、

The material selection of reactor, strength calculation, structure design ( including welding joint and flange seal face) and matters needing attention in equipment manufacture were analyzed and discussed comprehensively by the author.

作者对反应器的选材、强度计算、结构设计（包括焊接接头和法兰密封面）及设备制造中应注意的问题进行了较全面的分析和论述。

互联网摘选

16、

The selection of series reactor parameters, calculation formulas of its inductance value, and the method of its insulation withstanding test are introduced.

介绍了串联电抗器参数选择、电感值计算公式及绝缘耐压试验方法。

互联网摘选

17、

Structure type selection of resistor and reactor and temperature calculation under the condition of element heating and forced wind cooling;

电阻器与电抗器结构选型，元件发热和强制风冷条件下的温升计算；

互联网摘选

18、

Discussions on acrylic nitrile reactor carbon balance calculation methods

丙烯腈反应器碳平衡计算方法的探讨

互联网摘选

19、

Research on Advanced Pressurized Water Reactor Fuel Management Calculation Method and Program Development

先进的压水堆燃料管理计算方法研究及软件研制

互联网摘选

20、

The fitting parameter is adjusted according to the reactor physical calculation or the experiment of power calibration. The simulation result shows that the method can simulate the ex-core neutron instrumentation system accurately in real-time and meets the needs of NPP full-scope training simulator.

根据反应堆物理计算或功率刻度实验确定拟合系数，可以实时准确仿真堆外核测量系统，满足核电厂全范围培训模拟器的要求。

互联网摘选