Structural design of a new type of mixed phase reaction rectifying tower

1、

According to the current research research result, in this paper, reaction tower, air distributor, internals, exit configuration, separator and solids return feeder are expatiated.

根据现有的研究成果，围绕反应塔床体、布风板、内构件、出口结构、分离器和返料器等分别阐述。

互联网摘选

2、

MASS TRANSFER STUDIES OF INJECTING AERATED REACTION TOWER The Application of Air-lift Loop Column Filling with Porous Carrier in Wastewater Treatment

含有多孔载体的环流曝气塔处理污水的研究

互联网摘选

3、

Discussion about Technical Renovation of Caprolactam Oximation Reaction Tower

己内酰胺肟化塔改造的技术性探讨

互联网摘选

4、

Infrared Monitoring System Design for Lining Erosion in the Reaction Tower of Copper Flash Furnace Based on Multi-thread Communication

基于多线程通讯的铜闪速炉反应塔内衬蚀损红外监测系统设计

互联网摘选

5、

Anti-surge control of air blower for reaction tower

反应塔送风机的防喘振控制

互联网摘选

6、

Experiments were conducted on injecting aerated reaction tower.

针对射流自吸式曝气塔进行了试验研究。

互联网摘选

7、

Numerical simulation for flue gas velocity field at the entry section of SCR reaction tower

SCR反应塔入口段烟气速度场的数值模拟

互联网摘选

8、

70000t/ a Polypropylene Composite Pipe Type Reaction Tower Manufacture Technique

70000t/年聚丙烯组合管式反应塔制造技术

互联网摘选

9、

Flow characteristics studies of injecting aerated reaction tower

射流自吸式曝气塔传质特性研究

互联网摘选

10、

A measuring system for lining's shape of flash stove reaction tower

闪速炉反应塔炉衬内形的检测系统研究

互联网摘选

11、

Dynamic Model and Experimental Research of SCR Flue Gas Denitration Reaction Tower

SCR烟气脱硝反应塔动力学模型与实验研究

互联网摘选

12、

Life analysis and evaluation of cracking reaction tower

裂化反应塔的寿命分析和评定

互联网摘选

13、

Safety Detection on the Damaged Parts of the Chemical Reaction Tower

化工反应塔受损局部检测

互联网摘选

14、

In this paper, the design of a feedback compensation control system for reaction wheel of torque mode is introduced.

介绍了反作用飞轮力矩模式反馈补偿控制系统的设计。

互联网摘选

15、

The presented model not only takes into account the internal motion which the rod rotates about its own axis due to the use of flexible spherical joint but also analyzes the reaction torque generated by the elasticity deformation of flexible spherical joints.

所建模型不仅考虑了因柔性铰链的特殊性，微机器人连杆绕自身轴线转动的内部运动，还分析了柔性球铰弹性变形产生的反力矩。

互联网摘选

16、

In a dynamic simulation system for motor vehicle, the fidelity of simulated steering wheel reaction torque has influence on the operating behaviour of experimented drivers, so that has also influence on the accuracy of simulation of drivers' operation.

在汽车动态模拟系统中，转向盘反力矩的仿真逼真度影响实验驾驶员的操纵行为，从而影响驾驶模拟实验的准确性。

互联网摘选

17、

Simulation of Steering Wheel Reaction Torque under All Operating Condition by A Torque Motor

利用力矩电机全工况仿真汽车转向盘反力矩

互联网摘选

18、

Torque servo system design of reaction torque measurement device

反作用力矩测试装置力矩伺服控制系统设计

互联网摘选

19、

Design of Body Reaction Time Tester Based on Pattern Stimulus Signal

刺激信号为图案的人体反应时测试仪的设计

互联网摘选

20、

The reaction time under microwave irradiation was 45 min but the reaction time of traditional synthesis method was 10 h.

反应时间由传统合成方法的10h缩短到微波合成的45min；

互联网摘选