Fan-coil unit is an important kind of central HVAC system terminal device in our country, where its controllers are widely used.

To promote the higher stage development of the terminal market of our country, some valid measures and proposals were put forward'

为进一步促使我国批发市场向更高阶段发展，提出若干有效的措施和建议。

互联网摘选

At the same time, the rapid increase of container throughput caused by the gradual and annual increase of country export, and the developing trend of container ships' growing larger, have both raised higher requirement for container terminal of our country.

同时，我国对外贸易量的逐年增加所引起的集装箱码头吞吐量的急剧上涨以及船舶大型化的发展趋势也都对我国各集装箱码头提出了更高的要求。

互联网摘选

Study on Handling Technology of Bulk Grain Terminal of Our Country

我国散粮码头装卸工艺研究

互联网摘选

Combining the advantages of the two kinds of HVDCs, a novel type of hybrid HVDC transmission is proposed, in which at sending terminal the Phase Control Converter ( PCC) is adopted and at receiving terminal the VSC is adopted.

文中提出一种结合二者优点的新型混合直流输电方式，其送端采用传统HVDC的相控换流器，受端采用VSC。

互联网摘选

Based on the fact that electric power is output from the HF terminal of the frequency converter, this paper analyzes the causes and harms of higher harmonics, as well as the reasons for the power cable oscillation radiation during transmission and their solutions.

根据变频系统高频输出电能特点，分析高次谐波产生原因和危害，并给出在电力电缆传输过程中产生振荡辐射的原因和解决方法。

互联网摘选

Using single terminal inverse excitation type converter priciple, eight independent output switching power supply is developed.

采用单端反激电流型变换器的原理，研制成多达8路独立输出的开关电源。

互联网摘选

The remote access of video conference terminal by G.703/V.35 converter and V.35 modem

巧用转换器与Modem实现会议电视终端的远程接入

互联网摘选

Fault Analysis of Energy Meter During the Communication Between Load Control Terminal and Voltage Converter

负控终端与电压变送器通信时引起的电能表故障分析

互联网摘选

The simulation experiment with this method on a robot manipulator is implemented and good system performance is achieved. Moreover, using the fuzzy neural network ( FNN), a new intelligent terminal sliding mode controller is designed.

该方案在机器人手臂系统中进行了应用，取得了良好的控制效果。此外，提出了一种基于模糊神经网络的终端滑模控制设计方案。

互联网摘选

The mathematical model of AC servo motor is established at the base of kinematic analysis of parallel mechanism, and the fast terminal sliding mode controller is designed.

本文构建了2-DOF并联机器人控制系统，对并联机构进行了运动学分析，并在此基础上建立了交流伺服电机数学模型，设计了快速终端滑模控制器。

互联网摘选

Both linear sliding mode controller and terminal sliding mode controller are designed, and relatively satisfactory results are obtained.

分别设计了线性滑模AQM控制器和终端滑模AQM控制器，取得了较好的效果。

互联网摘选

LCD Computer Display Terminal and Its Controller

计算机液晶显示终端及其显示控制器

互联网摘选

In terms of the terminal node controller to connect the transmitter-receiver and computer that has RS-232, this paper explains the method of packet radio communication.

结合终端结点控制器、收发设备和具有标准RS-232接口的计算机连接方案，说明了实现无线分组通信的方法。

互联网摘选

25 protocol and proposes a way to implement the hardware and software of the terminal node controller ( TNC).

25协议的终端结点控制器（TNC）的硬件和软件实现方法。

互联网摘选

Remote terminal plotter controller microprocessor controlled display terminal

远程终端图形显示器控制器

互联网摘选

Communication terminal module controller

通信终端模块控制器

互联网摘选

Design of Multimedia Terminal Remote Controller Based on PIC Single-Chip

基于PIC单片机的多媒体终端遥控器设计

互联网摘选

This paper designs a multi-function terminal controller based on intelligent transportation system, it complete much functions such as real-time positioning, automatic report station, wireless communication, remote configuration, safety alarm and real-time display vehicle condition and so on.

本文设计研发了一种基于智能公交系统的多功能终端控制器，完成车载终端的实时定位、自动报站、无线通信、远程配置、安全报警及车况实时显示等功能。

互联网摘选

Next, aimed at the chattering of sliding mode control, an adaptive terminal controller without chattering is designed. This strategy can not only weaken the chattering, but also strengthen the robustness.

接着，针对控制器的抖振问题，利用高阶滑模控制技术，设计了一种二阶无抖振的自适应终端滑模控制器，达到既削弱抖振又不会大幅削弱系统鲁棒性的目的。

互联网摘选

The hardware components of RTU include the terminal controller, the data acquisition module, the GPRS transmission module. As well, the software design is aimed to guarantee the normal work of RTU.

其中，远程终端RTU的硬件部分主要包括终端控制器、数据采集模块、GPRS传输模块；软件设计主要是为了保证RTU的正常工作。

互联网摘选