That the low oxygen content continuous SiC fibers with 5%-6% oxygen content, can be prepared through two-step sintering program. Their tensile modulus with stable 2.2-2.7 GPa had been improved.

The experimental results indicate that the end-effect which is obvious in conventional test can be eliminated by this method, and then more reliable tensile modulus of polyester cord will be obtained.

结果表明，减法试验法能够消除常规测试中存在的明显的端部效应，从而可以得到较可靠的聚酯帘线拉伸模量。

互联网摘选

Suitable amount of wood powder was also helpful for the increase of composite tensile modulus, flexural property and heat distortion temperature, while it might decrease the impact strength and tensile elongation.

适量木粉能提高复合材料的拉伸模量、弯曲性能和热变形温度，但材料的冲击强度和断裂伸长率有所降低。

互联网摘选

The effects of glass bead content and its size on the elastic tensile modulus ( E) of the filled low density polyethylene ( LDPE) composites are studied.

研究了填充低密度聚乙烯中玻璃微珠含量及其大小对复合体系拉伸弹性模量E的影响。

互联网摘选

It was found that the elastic tensile modulus ( E) increased with increasing content of glass bead (), and a non-linear relationship existed between them.

发现弹性模量（E）随着微珠质量百分数（Φ）的增加而增大，两者之间呈非线性关系；

互联网摘选

The increase of draw ratios in three-stage drawing process decrease the linear density of PAN fiber and improve the strength, sonic orientation and tensile modulus.

三级拉伸工艺中各拉伸比的提高均有利于PAN纤维线密度的减小及其强度、声速取向度和抗张模量的提高；

互联网摘选

STUDY ON THE RELATIONSHIP BETWEEN THE MECHANICAL PROPERTIES AND PROCESSING FOR SELF-REINFORCED POLYMERS 2.Dependence of Tensile Modulus on the Processing and the Primary Structure of Polymers

自增强高性能聚合物的成型工艺同力学性能间相关性研究&2.超拉伸高聚物的弹性模量同其起始结构和成型工艺间的关系

互联网摘选

Dynamic mechanical analysis showed that the heat distortion resistance and the temperature of abrupt drop point for tensile modulus E ′ increased markedly with the irradiation dose.

动态力学分析（DMA）分析表明，聚己内酯辐照交联后的弹性模量和耐热性能显著提高。

互联网摘选

This article introduces a method to determine the plastic membrane tensile modulus by using a normal mart electron tensile testing machine and computers.

文章介绍了一种利用普通的智能电子拉力试验机配以计算机来计算塑料薄膜拉伸弹性模量的方法。

互联网摘选

It is well known that tensile modulus is assumed the same as compressive modulus in the classical theory of elasticity.

众所周知，经典弹性理论认为材料的拉伸弹性模量和压缩弹性模量是相等的。

互联网摘选

A master curve of tensile modulus is obtained through the equivalence principle of time and temperature, using the Arrhenius shift factor.

由时温等效原理按Arrhenius移位因子得到基准温度下的拉伸模量主曲线。

互联网摘选

The tensile modulus approximately equal to the compressive modulus of elasticity within the proportional limit.

拉伸载荷模量约等于比例极限内的弹性模量。

互联网摘选

Tensile modulus and yield stress of blends increase with concent ratio n of PMMA.

结果表明，共混物的拉伸模量、屈服应力随PMMA含量增加略有增大。

互联网摘选

Prediction of the Elastic Tensile Modulus of Glass Bead-Filled LDPE Composites

微珠填充LDPE复合物拉伸弹性模量的预测

互联网摘选

An analytical algorithm to estimate the tensile modulus of Brazilian disk splitting tests is presented.

提出巴西圆盘劈裂试验中拉伸模量的解析算法。

互联网摘选

Predicting Method for Tensile Modulus of Stitching Laminate by Finite Element Analysis

基于均匀化方法的缝纫层压板拉伸弹性模量有限元预测

互联网摘选

The tensile modulus showed a negligible change with thermal oxidation temperature.

模量随热氧化温度变化不明显。

互联网摘选

The density of RCF is only 1.39 g/ cm~ 3, and has a much lower tensile modulus of 50 GPa over PCF.

黏胶丝基碳纤维的密度仅1.39g/cm~3；拉伸模量很低，约50GPa。

互联网摘选

The correlations between tensile modulus, shear modulus and temperature of PA6 were obtained by linear regression.

利用线性回归，分别得到了拉伸模量，剪切模量与温度的相关关系。

互联网摘选

The experiment results show that composites with large braiding angle have complex crack forms under uniaxial tensile loading and the tensile stress-strain curves take on nonlinear characters.

实验数据表明：大编织角复合材料在单向拉伸作用下的破坏形式较为复杂，其应力-应变曲线呈现非线性特性。

互联网摘选

The experimental results showed that X-ray stress constant obtained under tensile loading was more than 10% higher than that under compression when 20 value method was applied to calculate stress.

试验结果表明，如果用2θ值法计算应力，那么拉伸加载条件下的X射线应力常数比压缩加载条件下的该常数高出10%以上。

互联网摘选