Based on the nonlinear dynamic theory, investigation of the mechanism of period-doubling bifurcation, tangential bifurcation, chaos and intermittent chaos are made. Their physical mechanisms are revealed.

The period-doubling bifurcation, tangential bifurcation, chaos and intermittent chaos are studied deeply.

本文重点研究了倍周期分岔、切分岔、混沌和阵发混沌这些非线性现象。

互联网摘选

Stereotactic Radiotherapy following Conventional Radiotherapy in Nasopharyngeal Carcinoma Rolling tangential IM-segment beam in the irradiation for the breast

常规外照射加立体定向放射治疗鼻咽癌乳腺癌旋转切线调强照射技术的研究

互联网摘选

Rolling tangential IM-segment beam in the irradiation for the breast

乳腺癌旋转切线调强照射技术的研究

互联网摘选

Higher thermal efficiency of plasma reactor and precise control can be gotten through adjusting tangential and radius air admission gas flow rate reasonably.

通过合理调节切向和径向气体流速，能够提高等离子体发生器的热效率并能对等离子体实现精确控制。

互联网摘选

Study on Decreasing the Surging Flow of a Compressor by Tangential Air Admission

利用切向进气降低压气机喘振流量的研究

互联网摘选

Influence of Reversed Tangential Air Admission to Aerodynamic Field in Boiler on Cold Test

反切风对锅炉冷态空气动力场影响的试验研究

互联网摘选

Considering that it is more meaningful to know the acceleration components relative to a moving trace instead of those along longitudinal, lateral and normal axes of targets, a time-varying nonlinear state model describing tangential and normal acceleration maneuvers of targets in three-dimensional space is established.

建立了描述目标在三维空间中进行切向与法向机动的非线性状态模型。

互联网摘选

The curvilinear model set constructed by this method is only related to tangential acceleration and normal acceleration can be self-adaptive adjusted. In doing so, computation burden is reduced and the algorithm's application range is extended.

用该方法构造的曲线模型集只与切向加速度相关，法向加速度可自适应调整，这一方面简化了计算复杂度，另一方面扩大了算法的适用范围。

互联网摘选

At present moment, the equations of torpedo motion are based on constant thrust. In order to introduce tangential acceleration into the control of torpedo trajectory, equations with variable thrust have to be established.

目前的鱼雷运动方程是建立在恒推力基础上的，为了将切线加速度引入弹道控制，建立变推力方程是必要的。

互联网摘选

The tangential acceleration formula has been deduced and lateral guidance law has been given when the RLV flies along the trajectory of HAC.

根据航向调整段轨迹的数学描述，推导出了沿此轨迹飞行的速度变化规律，并给出了侧向平面内的制导规律。

互联网摘选

Do not confuse ever the tangential acceleration, which is along the circumference, with a centripetal acceleration.

但是别把这个切向加速度，它是沿着圆周的，和向心加速度混淆。

互联网摘选

A Derived Method of the Normal and Tangential Acceleration in Circular Motion

圆周运动中法向和切向加速度的引入方法

互联网摘选

Tangental point of a cubic Line AB is three times longer than Line CD.

三次曲线的切线割点AB线比CD线长三倍。

互联网摘选

Tangental point of a cubic 3-D Line. Line with a 3-D visual effect

三次曲线的切线割点三维折线图。带有三维效果的折线图

互联网摘选

Tangental point of a cubic

三次曲线的切线割点

互联网摘选

On this basis, the surface heating is predicted with the above methods. Surface pressure distribution is provided with the engineering methods such as Newton method, tangent-wedge/ cone method, and so on.

在此基础上，对于无粘流区，采用牛顿法、切楔/切锥法等工程方法确定物体表面压力分布，利用等熵条件确定边界层外缘参数；

互联网摘选

The unsteady state term was discretized using the full implicitly schemes. For the diffusion terms, the normal direction vector ( the first diffusion) and the tangent direction vector ( the second diffusion) were calculated by using the intersectant and iterative algorithm.

对于非稳态项采用全隐格式，对于扩散项，采用法向扩散项（一次扩散项）和切向扩散（二次扩散项）进行相互交叉迭代的算法。

互联网摘选

This paper discusses correspondence between homogeneous polynomial vector field of even degree Q ( x) in R3 and the induced tangent vector field QT ( x) of Q ( x) on S2 and some geometric properties of solutions. The nonexistence of limit cycles is proved.

本文讨论了偶次多项式齐次向量场和S2上的导出切向量场之间的对应关系和轨迹的一些几何性质，并证明了Q（X）不存在极限环。

互联网摘选

This dissertation presents a definition of general offset curve, which has fixed offset distance, but variable offset direction. The offset direction is defined by the local coordinate system, which is formed of the tangent vector and the normal vector of every point on the curve.

本文利用曲线上各点的切向量和法向量所形成的局部坐标系来确定等距方向，从而给出一种广义偏距曲线的新定义。

互联网摘选

A special kind of unabridged end conditions like wing is used in the interpolation of curves, it needs both radius of curvature and tangent vector perpendicular to chord line, and has been solved very successful by special processing.

其中一种比较特殊的完备边界条件是翼型条件，它要求在端点处有垂直于弦线的切线，并且具有给定的曲线半径；

互联网摘选